Network Security

Dear All,I will like to use the pix dhcp (on the inside) to deliver the same IP address to the same PC every time. eg. registering the mac address of the PC. This becaouse I only what that specifik host to be able to go over the L2L VPN, this is in a...

Is there a way of indexing individual VPN Tunnels statically, through a VPN3000 concentrator? If I MIB browse a VPN3000 concentrator, I can see the individual VPN tunnels each with ifindex numbers, so for the period this tunnel is active, I can colle...

Can i configure the PIX´s outside interface for PPPoE and normal ethernet at the same time?I need to communicate a PIX 501 with an ADSL ISP and a partner´s extranet (with a 1600 router)Thanks in advance

I need to advertise route from the inside of the pix to the outside of the pix. I am using EIGRP inside and outside(but can use any routing protocol). Is this possible? If so what is the best way to do it?Thanks,Jamey

Hi,I'm encountering a problem using PDM ver 2.1. I cant see the ACL in inside interface. But yet i can it in CLI. Any advise? thanks.

I am looking for documentation on installing an additional Ethernet Interface card in my Pix 525. Before I started managing this Firewall there was already an Gigabit Interface card installed. Can you guide me where I can find this informaiton.

hi,i want to connect 515E pix along with 7200 BRAS router but just have 2 interfaces of pix 515E.so kindly tells me the step by step configuration of pix along with 7200 router and 3550 series switch.plz remember i want to use only 2 default interfac...

In our office we have 2 router and 1 pix 515R firewall i am able to ping and TFTP inside router but outside router i am not able to PING not TFTP from any host......is these because of NATING in PIX..But i am able to ping the outside router from PIX

we have an Oracle applications server behind a PIX 515. The oracle has a web interface listening on port 8001. We have statically opened port 8001 for the inside oracle machine but the oracle application is not accessible. We have fixup protocol sqln...

A bit of a novice at all this. I have spent a few days trying to get a vpn setup to a remote site.We have pix 515 at both ends. I need VPN connection to a server at remote end.I setup the config at the remote end but the vpn connection failed. I have...

I am having trouble finding a document that describes setting up a GRE Tunnel through a 3000 Concentrator.Here's what I would like to do. I want to create a LAN/LAN VPN with IPSEC/3DES from a remote router to a Cisco 3030 Concentrator. Also with this...

I have upgraded my pix from 6.1.4 to 6.3.1, my piw work with failover, it works well but there is a warnning shown on the standby unit. this warnning is:WARNING, missing ip or failover address on inside interfacerdWARNING, missing ip or failover addr...

hi,does anyone know if it is possible to forward traffic from a logical interface on eth1 with security 50 and vlan2 mapping to the outside interface sec0,the eth1 is configured as a physical interface on the native vlan with sec 100.The problem is t...

I have a PIX 515E in place and it is running NAT. I would like to take off the NAT and not have any address translation. I have never setup a PIX this way. What do I do?Bill E.