Network Security

What ports need to be opened up on a firewall to allow outside access to a Windows 2000 Server running Terminal Services?

I have upgraded a pix from 6.3.1 to 6.3.3 and now the PIX keeps on rebooting. Downgrading doesn't have any good result! I can find any answer on the site. This is the error message:An internal error occurred. Specifically, a programming assertion was...

I have a site to site VPN currently in place. I am using a 2600 on my side. I now need to get remote access for home users implemented. I am getting error: 412: Secure VPN terminated by locally by client. Remote peer no longer responding. Below is my...

Is anybody running CNR 6.0.5 on Windows 2003? Are there any known issues with this?

I have a very basic config on a PIX515E with 6.3(1). Approx. every 10 min I loose connection with the firewall from an inside host and can not get out to the internet or use PDM. The firewall can not ping the inside host. Below is the config.If I sub...

Is NTP Server support is planned in future releases of PIX Software?Thanx

I have a customer testing Polycom video conferencing over the Internet through their PIX 506. They have a single public IP address so all outbound traffic is PAT. When they initiate the connection the recipient sees their video feed but they see none...

Having problems connecting to inside when using www or https, but telnet is successful. Below is our config.Any ideas?access-list outside_access_in permit tcp any host X.X.X.X eq httpsaccess-list outside_access_in permit tcp any host X.X.X.X eq wwwac...

hi,I have two questions about pix 501 and logical interfaces (vlan's):1. is it possible for a pix 501 to create on the switch interface of the pix two VLAN's 1 for inside lan and 2 for DMZ?If so then I have 2 logical interface2. If it's possible to c...

How many interfaces in total supported 515E including logical(VLANs by 802.1q) and physical? on CCO it is 8 Logical and 6 Physical. Effectively I should get 13 Interfaces (1 Physical Interface needed for trunk), right? But it says maximum 10...is it ...

Hi guys, mind looking at my config and helping me figure out why any box in the DMZ can not be accessed from the outside.. They also have no access to the net? I looked at couple example configurations and i must be missing something every single tim...

i understand that ospf is supported on pix 6.3..But how it is implemented..i couldnt see any sample configurations or even documentaion guidelines on how to implement it...anyone could suggest any link pls will be greatly appreciated.

I have a PIX 506 that was connected to a ISDN with a static IP. Now we went to ADSL and we don't have a static IP. Is it possible for me to set the outside adapter to DCHP and have it work correctly? From the limited reading I don't think it is posss...

I'm trying to connect a PIX FW and a VPN 3015 with the use of certificates.I followed the instructions found in TAC, but at a given moment there's a command that configures your CA server to get the certificates, and it's here that it goes wrong.--> ...