Customer will deply CW2K RWAN and LMS (only selected products) on up to 4 SunFire 280R servers. They have around 820 routers and 1,800 switches. I'm wondering is a single servers might support CD One, RME and Campus Manager with RME Availability Mo...
I use IDS sensor version 3.1(3)S36 , and pix version 6.1(4) , and I am trying to do shunning on pix using telnet . But I face the following problem in the errors.managed :12/17/2002 13:32:06UTC E Read error [Operation now in progress] fd [3]12/17/200...
Hi,Is it possible to log the output produced by "debug" commands to syslog? I do succeed in sending debug level information (%PIX-6-*) to the syslog, but what I would really need is low level output. (e.g. for a "debug fixup tcp" I want the "tcpseq: ...
Hi everyone, I have a quick question, i have two pix 501, both has a 10 user license, i'm going to create a LAN to LAN tunnel between them. Just want to make sure, how the pix going to count how many user conneting, by session? source IP or by MAC ad...
I have any server ( DNS, SMTP, www) in inside interface with private IP address.With static command i traslate public address in private address:static (inside,outside) 200.21.225.243 mail netmask 255.255.255.255 0 0 static (inside,outside) 200.21.22...
Would appreciate feedback, I have configured a couple of pix configs before with little difficulty. Im running into problems. First of all, I've read conflicting articles......Can you have one public ip on the outside then nat on perimeter then have ...
How do I keep a log of the PAT/NAT translations running on a PIX for a future analysis?I have tried to log it with syslog and SNMP MIBs but I couldn't find the right object or line in the syslog.The informations that I am trying to get are the same a...
I need to install one PIX 501 in a network . The internal interface is connected in my LAN e the outside interface is connected in interface e0 of the router.The LAN have llc2 and IP traffic. Is possible to pass the llc2 traffic in the firewall with...
It is my understanding that you can NOT use the PIX to route between two subnets connected on the same inside interface. The PIX will not take receive packets and send them out the same interface that it receives them on. In other words, the PIX will...
Hello,I realise that this question has been asked in many different ways, but I haven't seen my way yet. My problem is We have a pix515e with 6 interfaces, all interfaces can get out to the outside world fine but they can't cross over to each other. ...
I have a need to monitor the internet usage of a single workstation with a static ip address. Is there an easy way to do this? I have a PIX 515e. Any help would be greatly appreciated.
Hi,We are currently testing a PIX 515E with 6.2(2) software.Now i have had this problem 3 times that PIX "inside" and "outside" interface would be shutdown automatically without any SYSLOG message being logged.If i look physically at the link , both ...
We are getting ready to deploy 6 VPN 3000 in sets of 2 for fail-over. As part of this product we purchased VMS 2.1 under the impression that it provided a centralized management console for multiple VPN 3000 concentrators. However, I cannot find any ...
