Other Collaboration Subjects

IP Phone non-stop ringing after PSTN caller disconnect the line.PSTN caller call to IP phone thru H323 gateway FXO port, gateway pass to CM, did not pick up the call, caller disconnect the call, IP phone still ring. there is no problem gateway pass ...

I have a customer that wants to know if at one time did Active Voice support an integration with the First Class email system? If so, is there anything out there that goes over how it was integrated, what is needed for the integration, etc.? I unde...

In Exchange, Unity creates a new recipent container in the address book under "Local Recipients" called "Distribution Lists". It is populated with:All Subscribers - UNITY1System Event Messages - UNITY1Unaddressed Messages - UNITY11. Can we rename th...

Hi all , We can send faxes from the 827-4V endpoints out to remote PSTN connected fax , but we cannot receive at the 827-4V´s -- handshaking occurs between faxes but the call always drops and no fax data gets through. I have run "debug vtsp sessi...

I'm having trouble finding a document that describes how to set up an mgcp gateway to use srst. I know I need 12.2.(11)t. What I don't know is which h323 commands I still need to keep it working during srst. Do the mgcp commands override the h323 ...

We are operating with CM V 3.2(2c) and a WS-X6608 gateway for PSTN-Breakout via a Nortel Merdian PBX in a test environment. This breakout trunk now doesn't work anymore and we have the following error symptoms:-PBX-Amistrator says, he didn't change...

We have a new installation of callmanager. We had to start with 3.08 and then upgrade to 3.0(12). Then we went to 3.2(2c). The publisher install went fine. When we try to install the subscriber the same way applying all of the hotfixes and sql up...

We have a dual integration (Definity G3/CCM) Unity version 3.1.1. The CCM side has been fine for months, but if someone calls into the G3 side, periodically it will cut the caller off and ask them if they are finished. I have listened to some of th...

Is version 4.0 going to provide a way to better maneuver around a mailbox through the phone? For example: go back a message, move to say message 9, etc. Thanks.

I have a hybrid install with Unity servers being deployed across a globalenterprise. By hybrid I mean in some situations a CCM/Unity install isdedicated to a particular site, and in other cases, small 8-15 user smallbranch sites will use a larger si...

Every few days I have a dozen callers in teh Example Interview. I have gone through and checked, and I CAN NOT find out how they are getting there. Is there a utility I cna use to look to see what is linked to that and fix it?Thanks -Mike

Hello.I have some questions about the IAD2400 series:1) Can it act as a Voice gateway by connecting 16 analog phones (using the 16 ports FXS) to an IP network, running VoIP, using the 10BaseT interface ? In other words - can i run VoIP over the Ether...

Do you know if it is possible to connect an IP Phone running H323 version 3.2 to CCM 3.2 or does the H323 version not matter ?

I'm connecting one 1751 on Siemens PBX through ISDN BRI QSIG port.The IOS is 12.2(4)YH and the problem is that the router are trying to establish a conversation in channel 0 instead 1 or 2. Then the PBX refuse the incoming call.Is there any way to co...