Is it possible to mask or replace the Caller ID for internal IP-> IP phone calls. I cannot find a setting anywhere in Call Manager to do this. Added to this it only has to be done for some numbers, not all. Any tips appreciated.RegardsMike
I have two site with one CCM and some IP Phones in each. The WAN connection is a Leased Line with 128Kbps.It's possible to backup one CCM by the second if it's fail ? and vice versa ?
My network users are complaining that the voice in Unity (I am not sure if her name is Sally or Leslie) has a low volume. It think this can probably be increased under 'conversations' for both individual subscribers and all subscribers (via the temp...
Anyone having problems with headsets on the 7960 ? I have tried two seperate types of headsets and the XMT volume to the caller is very low, I have adjusted the xmt levels on the headset base, but can barely hear the caller from the 7960... Comments...
Setup: CM 3.2.1 - 2 Servers 500+ IP phones (7910, 7940, and 7960)Question: Is it possible to setup a route pattern to only allow calls to internal extensions and prevent a phone (s) from dialing an outside line? I created a route patter...
In other words, could I have cisco AS5300 connected to PSTN via pri and also connect directly to another cisco AS5300 across IP WAN?I see that cisco uses two routers on the WAN connectivity part, could they be eliminated if what's described above is...
On the IP phone, there are two ports, (port 1 and port2) which can be set. Can these be configured or set other than setting ports on the switch? Are these your PC port / LAN switch port as well and can one be shut down or disabled and have the ...
when I boot my AS5300 I always see this message.. does it have implications if it will support all hardware?Firmware version mismatch for bundle AS5300 VCWare - version found (7.23) is lower than minimum required (7.39)Firmware version mismatch for ...
I have found the bug id CSCdx32429 on the Bug Navigator Tool. I have the same problem on my installation and the Bug Details don't give me any kind of workaround.Is it possible to add new users to the global directory in any other way?Thanks.
Do we have to create webattendant console user in order to pilot number and hunt group work? We set up pilot number and hunt group purely for ip phones, it didn't work. Version 3.12c. Any idea?
when I boot my AS5300 I always see this message.. does it have implications if it will support all hardware?Firmware version mismatch for bundle AS5300 VCWare - version found (7.23) is lower than minimum required (7.39)Firmware version mismatch for ...
I was wondering if anyone has done something similar to the following:pots-----AS5300----voip------DEV?------pots (ivr)I want all inbound calls to go to the AS5300 running our IVR then do a voip call to another device which then does a ...
Hi, May I ask that is there any tool which can convert G729 format file to G711 format and vice versa? If there exists such a tool, would u pls tell me where I can download it.many thanksDavid
I have two sites connected by 256K leased line, each site has a cisco 2620 router connecting to PABX with 2 E&M module to fufill voip. The voip function good. but I find a strange issue, I call from one site to another through voip, the conversatio...
I have a cisco 1750 with two FXS voice card. There are many errors whick like "DSP timeout on event 6: DSP ID=0x2:" I can't make any calls to other router. I use IOS 12.1(5)T8. What is the problem ? Is it a IOS problem?
