Other Collaboration Subjects

dear all,the last approved DL320 (HP DL320-G5 Server with Intel 3050 Xeon 2.13-GHz Processor) is not orderable anymore and also showing up as "older server" in the Cisco supported HP servers overview.anybody knows about a new supported hw config with...

Hi,I am trying to setup CCIE lab.How much differ between uccx 5 and 7?I only have media for 5 and knew enough to be dangerous. ;)Thanks,

CCM 7.02, CUPC 7.02 I have MAC users who leave their CUPC up overnight complain that the client is unresponsive the next morning and have to restart the software. Is this expected behavior? Thanks.

Hi,can anyone help in in resolving Cisco 7936 Conference issue.Problem is : I have a Cisco 7936 Conference station phone which says " Unable to contact to TFTP Server " Its a DHCL configuration and iam ping the phone from the network.Is there any on ...

Hi,I have configured Publisher & added node licenses & phone licenses. But when I am going to add a subscriber, it first check connectivity validation & shows error. after that it gives a message that, My publisher server is not the forst node of th...

Hi,I am looking for cucm/cup/ipcc installation/configuration slides, videos. Are there any good sites like ciscounitytools.com?Thanks,

Dear cisco team, We're experienced problem with fax using ATA-186. We've tested either using fax relay or pass-through. When using fax relay, the ATA-186 can't disconnected the call to/from fax machine. And if we using fax pass-through, the fax machi...

Hey there, I'm an old phone tech and I'm looking to expand from regular telephone systems into the VOIP market.What I need to know is whether a VOIP system can be hooked to regular dial-tone? I basically want to hook the telephone numbers into the s...

I have MGCP gateways that configured as SRST gateways too. I have translation from internal numbers and vice verse then I use in config. Here is the final result:<b>voice-port 0/0/0:15 translation-profile incoming 1 translation-profile outgoing 2</b>...

Could some one advice me the materials i need to take for CVOICE 6.0 642-436 exam?

Does anyone know of a way to remotely change the network settings on a 79xx phone? We would like to use a tool or script to make sure each phone is set for auto negotiation.

Hi there,A customer got a fax in which more than 100 fax numbers (e.g. 012345678) of other companies have been pre-configured. Now they have changed to IP telephony and we have connected the fax through a Cisco ATA 186. With IP telephony they have to...

Hi,Have the IP Phone 7941 working with CUCM 6.x.Both of two buttons configured with specific DN (line #1 - 101, line #2 - 102).When I want to make an outbound on/off-net call from this phone I do one of the following:1) Dial the number at first, the...

Hi,Have CUCM 6.0(1), several IP Phone 7971 with several 7914 Expansion Modules."Device Defaults" shows there is S00105000300 load info (i.e. 5.0(3) firmware) for 7914.I want to upgrade firmware to 5.0(4) for my test purpose.The question is can I cha...