Hi Please confirm whether QSIG or ECMA QSIG is supported in SIP gateway in PBX-to PBX mode? Presently we are planning to use Cisco Call Manager 5.0?Thanks in advance.With best regards,Mani
I want to add a new softkey to my phone to have access to all my spedd dials. Someone say me that it is possible. I want to do that to my Cisco IP phone 7912 beacause I only have direct access to 4 of my speed dials.Thanks, Carlos.
hi all,I need ASAP all the information possible about the LDAPSEARCH.LDAPSearchList.1 Everything someone can find is helpfull for me.Thank in advance!!!Koos Duppenkoos.duppen@skynet.be
router: 2801 12.44xc3 / cm4.13sr2when the phones are in srst mode, call pickup or Gpickup doesn't work trying to pickup another extension. The phone says "feature not active here"thanks.....
Running CME4 on ios 12.4-4XC2. 7940-7960s at P0030702T023. All FXO calls come into receptionist and she transfers call to internal phone. Internal phone can hear outside caller but outside caller cannot hear internal phone. Sometimes placing the ca...
I have an intersting ring back problem.I have CMS 4.2.1 and a 2621 GW with a FXO and a FXS installed.From all phones analong or IP if I call within my area code I do not hear a ring back but when I call to a outside area code or a LD call I get a rin...
problem with intercom system, we use a intercom system here at work and what happens is that when someone is talking the signal becomes distorted and it seems to lag and then pick up then lag again, this happens on the intercom system and also with o...
I guess you're as confused by that as I am. The AXL Operation addDeviceProfile supports location and devicepool, even though a devicepool has neither. There's a bunch of other attributes that make no sense for a device profile.
multipledirectory.asp is working fine on a 7960 and 7940when I try to use it on a 7961 or 7941 it does not work I have the directory search on the 7961 screen but when I highlight it and try to search nothing do not receive the screan to enter name ...
Hi,I have set the user-local to IT (italian), and have 2 7960's and 1 7912G.The 7960's pick up the italian display on the phones, but the 7912 does not.Any tips would be highly appriciated.
Would like to confirm the below two dial-peers behavior. dial-peer voice X pots destination-pattern 9T port 0/0/0:23dial-peer voice X pots destination-pattern 9.T port 0/0/0:23With 9T, the prefix 9 will be attached or dropped when it is sent out to P...
