Hello Cisco ,i have the below class-map and policy-map statments located in a cisco WS-C4506 running cat4000-i5s-m code, can you tell me what they are used for? any help would be greatly appreciated. Thank you Charlie class-map match-all cm_att_...
Hi Sir,In a switched campus network, given a MAC address, is there any tool that can trace the MAC address to its source switch, i.e. the switch to which the host with that MAC address connects?Please advise.Thank you.B.Rgds,Lim TS
I use a router as a DHCP server. Now I´m using manual binding to asing ip, nex-server, bootfile, default-router, client-name, dns-server, domain-name.Is it possible to binding all parameters using static-mapping ( reading a text file)?. The documenta...
I have two 3725 routers running IOS 12.4. They are both connected different 4500 series switches. The switches are running layer 3 and the networks are subnetted such that it appears that there are different networks connected to each router. They...
On our core network devices, we are running HSRP in a number of spots. I'm of the impression that we'd need to set the syslog level to be at least level 6 (informational messages) so that we would see any HSRP state changes. I've confirmed that the l...
Hi,When testing one GE PortChannel, formed by two GE Physical links, with two Smartbits 6000B, we can see that when the PDU is smaller than 300 Bytes the 3550s can't forward all the 4Gbps (2Gbps bidirectional). Worse than that, the Smartbits say than...
When I upgrade a existing 6509 catalyst switch with a SUP720, what else do I need to have to support this new module?I am replacing a Supervisor 2 with only a PFC2. There is no MSFC2 today.
When I order WS-F6K-MSFC2 upgrade kit, is their anything else that I will need to order beside the software?Is there anything else that is manitory so that I will have layer 3?
Does anyone know whether the 2500 series ethernet ports support full duplex? I have been trying to configure ports for Full but receive an error message "This command is not supported for ethernet0".I have been unable to find the answer to this in th...
I am trying to access an Arrowpoint CS-150 content switch without success. What is the setup for hyper Terminal and do I use standard Cisco Console cable to connect to the device?
can't see multicast mac-address on a Cisco-Switch ! should i see the multicast mac-address from a node (Server, Firewall, etc.) which is connected to a Cisco-Switch L2 or L3-Port(29xx/35xx/45xx/65xx..)Switch-default: IGMP + IGMP-Snooping enabledno MC...
I have a cisco 2600 with a c2600-is-mz.122-23a.bin system file. This router has several sub-interfaces set up for the different vlans. Each vlan is encapsulated with ISL.The 2600 router connects to a C2912MF-XL switch with IOS version 12.0(5.2)XU.T...
Hiya, I have the following kit:- WS-C6006 Software, Version NmpSW: 5.5(8) Copyright (c) 1995-2001 by Cisco Systems NMP S/W compiled on May 15 2001, 15:06:17 System Bootstrap Version: 5.2(1) Hardware Version: 2.0 Model: WS-C6006 Serial #: TBA03360148 ...
