Other Network Architecture Subjects

I am looking at the potential of using a Cisco 2811 router for 10 Mbps to 10 Mbps (LAN to WAN) routing.I have performed a number of baseline tests, and am concerned at the CPU loadings. The router seems to be capable of forwarding approx 60Mbps under...

We have these new IBM laptops that have the Intel 1000Pro gig cards. When we connect them to any of out catalyst switches (4006 or 2980) it takes about 15 seconds to negotiate something. But when I connect it to a cheep SMC switch it does it in abo...

One of my customers has a legacy 4006 switch in the core with a Layer 3 blade in it. The L3 blade is where I route between VLAN's on the network.The network administrator this morning indicated to me that he is only seeing a fraction of the machines...

Hello Everyone, My customer requested me to connect two Cisco WS-C3548-xl using Gigastack connection to both Gigabit Ethernet 0/1 interfaces on both switches. This was completed and spanning-tree did it magic. I have a question or two. First Qu...

Hello,friends:I am a chinese man,so please forget my pool english first!I have two servers and there are two jboss servers on each one servers.I use LD 430 to load balancing.The before configuation is below:lb(config)# show config......hostname lbno ...

Hi.. By the way i found out that this forum is very helpful..I manage a network that stretched in many sites..the manage is done from one place , that is the Backbone. (i manage cisco routers,switches).the remote Lans has its own technicians it means...

I am looking for the proceedure to load the IOS on a 2948G-L3 that had it's flash erased. The "ROM: System Bootstrap, Version 12.0(7)W5(15) RELEASE SOFTWARE" does not support the XMODEM recovery proceedure that I found on CCO. Per the recovery procee...

Hi all,if I configure the 6500 catos configuration register with:- 0x02- 0x2102- 0x102are the same ?thank you,G.

One of my customers has a legacy 4006 switch in the core with a Layer 3 blade in it. The L3 blade is where I route between VLAN's on the network.The network administrator this morning indicated to me that he is only seeing a fraction of the machines...

Hi. Can anyone give me more information on implementation of VMPS? I need to know if our access switches that would be part of the VMPS network environment "must" be configured for VTP client or server switch modes to work with VMPS. At the moment we...

I have successfully used the reboot & space bar method to do password recovery/reset on 2651's,3662's, and 3745's, but I can't get it to work to any of half a dozen 1760's I have (new job). My Fujitsu laptop with XP doesn't do CNTRL-break or CNTRL-F6...

Hallo!I would configure a VRF on a C6009 / Routing Module (MSFC Software (C6MSFC-PSV-M), Version 12.1(22)E1). To create vrf with the command ip vrf GuestLanrd 111:100is very simpelif you type te commannd on the vlan interfaceip vrf forwarding GuestLa...