Other Network Architecture Subjects

everybody, I am having a bit of trouble getting traffice to flow from one lan across a P2P to certain hosts on the remote lan. I am using two 1720s over a T1.Two sites NC and NJNJ = 10.239.140.0/22NC = 10.239.134.0/24WAN = 192.168.100.0/30I'm trying ...

After loading the current PDLMs and configuring QoS, any P2P traffic except for gnutella is effectively blocked. The limewire or gnutella based users can download files but the kazaa users are limited. Here is the config: Class Map match-all MUSIC ...

DS = distribution switch 4506AS = Access switch 3550 DS1 ----------------- DS2 ||| ||| ||| ||| |||-AS11-AS12-AS13----||| || || ||--AS21-AS22-AS23-----|| | | |---AS33-AS32-...

I am adding a VPN circuit to a branch location that has a frame relay link. I would like to send specified traffic over the links (i.e. exchange traffic over VPN, SAP over Frame Relay). What is the best way to accomplished this setup? p.s. Both ci...

Hi,Could some body help me with this? I have two Cat6513 running Port-channel between them.Does anybody know where should I apply the service-policy command? On the Physical interfaces ( Gigabitethernert ) or on the Portchannel interface? Also I foun...

Dear netprosanyway to access the router through aux port?my problem is : when i tried to access the router through the console ,i cant type any character and as the router is empty , telnet wont be a solutionplease helptks

1)Hi How I can change the revision number in the vtpexamplerevision number 16I want to put it in 1. How I can do this?2.- In a Catalyst 6513 how I can switch between the active supervisor and the standby supervisor?

Will Catalyst 3750 be able to accomodate about 100 routes when configured for OSPF routing? Any performance issue? Is there guidelines to follow to so not to degrade the performance?

Hi,Can anyone shed any light on why this feature is called QoS Policy Propagation. From what I can gather, you can use a policy to apply ip precedence values to BGP routes installed in the RIB, which then marks incoming packets on interfaces where y...

i have 3548L2 switch connected to 7513 via fast ethernet. I am doing trunking between them. I had a problem earlier that i was gettting CRC and fast ethernetexpereincing errors messages on 3548 but we were able to fix it by changing trunking encapsul...

Hi...I have configured an MST name on the core switch and mapped the management vlan to instance 1 and the rest of vlans to instance 2. But on the edge swithes although i have configured the stp mode to mst but the vlans are all still mapped to insta...

What is no network command and no router ospf process-id command?I haven't see the commands.Please, comment.The following is the question that I saw.TEST1,2,3 router have area 0.A company has decided to network three locations to improve efficiency. ...

Hi All,We hv a hub and spoke wan network with one central location and multiple branch location.At one of our spoke location we want to implement QOS.Topology is Branch Lan-Router-ISP-Central Router-Central Lan.Branch router is cisco 1760 with wic-1...

Hi all,The command reference entry for 'neighbor dmzlink-bw' states that:"The link bandwidth extended community is passed to only iBGP peers configured in the VPNv4 addressfamily and is not passed to either iBGP peers or route reflectors in the IPv4 ...