Hello,I want to configure a router 2600, whom interface console is destroyed.Access by hyperterminal is not possible and the ip address is unknew.What can i do to ?Best regard
I working with a network and I use the Maximun flow solver to determine the bottleneck between two nodes. I determine the occupied index (Occupied Bandwid vs. Total Bandwid) all the month. Next I search the traffic edges tendency to simulate with the...
Strange problem in our campus. Computer (connected to 6509 switch) successfuly obtain IP address from dhcp server but this PC cannot ping default gateway and other devices on network. This PC also has Ip address conflict but there is no PC with same ...
Someone told me there was something call a TACS Server that I could use to manage the passwords and configurations on all my Cisco devices. Is there such a thing and if so where do I find it. Google search did not return anything usefull.Thanks
I currently have two Cisco PIX 515’s in failover mode connected to my core switch (C4003). Also on that switch, I have a print server that I need to traffic shape because some customers are getting their link saturated. The customers are printing t...
I have a 6500 sup720 (running integraded ios (native)), there has been executed a ssh connection to another router when connected to the console port. This ssh connection freezed and now I can't access the console port. When executing show user, I'll...
I have a 1760 with 2 FXS ports. I connect FAXs on both FXS ports and I try to make a call but it's not succesful. I can call a remote FAX (VOIP call) with no problem, but when there is an incoming call, the FAX answers the call but cannot handshake a...
I have a 3660 (12.3) with WIC-1MFT installed connected to a T1 broken into 8 128kbs (2-channel) point-to-point links. Each link terminates on a 1720 that passes data back to 3660. My problem is that the WIC-1MFT only will support 2 channel groups. Al...
Hello All : I had meet the problem about cisoc3750 connect to Extreme Switch . At Begining the link is work fine ! but after 5 min / 10 min , the link dow/up flapping . Then come back again ! even config " No keepalive , speed 100 , duplex...
Dear all,I am having too many Secondary interfaces created on a Fast Etherntet port of a router.I want to run MRTG. Can anybody tell me that should can I run MRTG based upon IP or Cisco switch is needed for it?Regards,Tushar
Hi All, I have six location (site A,B,C,D,E,F) connected through Sprint MPLS network using BGP with private ASN. site A has internet connection and it's works great.Now I want to install secound Internet connection in Site B as a failover.What ...
