Is it possible to aggregate routes received from a neighbour? The Neighbour is in a different AS so teh peering is EBGP. Many Thanks
Is it possible to aggregate routes received from a neighbour? The Neighbour is in a different AS so teh peering is EBGP. Many Thanks
I have this error showing on a member switch of a cluster setup through the web interface.I have verified that both switches are set to use VLAN1 as the native vlan, and since these are internal switches CDP is running on both.Both are Catalyst2924XL...
Can anyboy clarify whether I can install a new switching module (6 port 1000Base-X) into a Catalyst 4507R without switching it off ?Thanks.
Hi, We have 5 Cisco Catalyst 8540MSR ATM switches.We have been using them to switch PVCs between different routers, but we would like to finish some of the PVCs in the switches.As we have seen in the Cisco documentation and examples, it seems that th...
Hi,Can u pls let me know what is the requirement for enabling Netflow switching on Cisco 7206 , 2800 & 1841 routerAlso can u let me know the entire components required for netflow like Netflow collector s/w any spl. hardware req. etc.Regards
the PA is good on 7206VXR, but crash VIP4-50:
when device's IOS lost,and reload in ROMMON> ,,,how can i set the router to load the IOS from TFTP ??
Hi,I got two Cisco WS-C3548XL, each one have a GBIC 1000Base-SX tranceiver (WS-5484) and they are connected together with a fiber. It's work very well.Both have IOS version 12.0 (5.3)WC(1)Here my problem:We have decided to change this topology and we...
can you stack a 3750 runing EMI with a 3750 that has SMI software on it? I would to know before i make a mistake purchasing one. haha. thanks for the response.
Is there a way to monitor traffic levels (via snmp and CLI command) on the backplane of 6500 switch? We are running in native mode with a MFSC2/SUP2.
I have 55 routers connected into an ATM/radio network. I am running EIGRP. This network basically acts a bridge. All Router WAN ports are on the same subnet. There are 6 main locations on this network with up to a dozen of my routers hanging off ...
Hell-o,We are a small community college, who's present infrastructure design is flat...all switching. We purchased a 4506 in order to redesign the network to layer 3 and create Vlans. Can anyone direct me to any documentation on implementing layer ...
Hi all,Just wanted to know if the commands 'distribute-list and offset-list' are supported under 'router isis'.Not able to configure the same. Appreciate any documents supporting this.Thanx in AdvancePraful
Does 2600 ISDN BRI support call bumping if connected to ISDN provider's NT?thanks!
The NM-2CE1T1-PRI network module seems to support E1 channelized mode.How many channel groups (Nx64) are supported on a single E1 port ? each channel group being a bundle of N timeslots. is it possible to have a PPP link associated to each channel gr...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
08-07-2024 06:15 AM | ||
07-17-2024 11:08 AM | ||
07-17-2024 06:07 AM | ||
05-29-2024 04:52 AM | ||
02-14-2024 04:00 AM |