Other Network Architecture Subjects

Hey guys,I'm trying to do a VLAN trunk using dot1q on a 2621XM running the c2600-i-mz.122-12j.bin image. It's just not letting me, claiming encapsulation is a bad command within the interface or subinterface of the Fast Ethernet port.c2600(config-su...

Most documentation on CCO leans towards hard coding NIC's for servers, routers, switches, etc. I have done tests in the past with correctly negotiated 100/Full links and hard coded 100/Full links and throughput has always been better on the hard cod...

I am trying to get a VPN circuit up, but have not been able to get any connectivity over the WAN.The near-side VPN source (3725rtr) is an internet-facing interface with a public IP.The remote VPN destination (2621rtr) is an internet-facing interface ...

Hello,I'm not an expert on router.I need to connect 2 or 3 modems (DSL + Cable) to use on a Lan.I don't know what product I can use to make this.If someone can help. Thx

Does anyone know if it's possible to tell if a 2600 is one of the XM variety remotely, via CLI?

I need to replace 5500 access layer switches and considering using 3750's. In some of the access layer closets I may have to stack up to 7 switches. Does anyone have a site large enough for this requirements and have you experienced any technical is...

HiI'm trying to set up a 2514 (11.2) in a lab environment to allow everything from one interface to be passed on to the other interface. My only goal is to have a private subnet on one interface and the other interface connected to a switch.In my cur...

I have to buildings 50 miles apart. I have a T-1 connecting them. Building A is able to receive internet service, building B isn't. So i set up a NAT to feed service from building A to building B, the ISP is Road Runner. Each site has a cisco 2650 r...

Hi...Can i disable Syslog at the CiscoWorks? and if yes, how?Many ThanksAbd Alqader H.HNetwork admin

currently the 2948 is set to switchport mode trunk. i want to gig-attach the 3550.i've enabled switchport trunk encap dot1q on the 3550 but don't see any cmd like that for the 2948.can someone shed some light on this on how to enable dot1q between t...

Hi,I want to view the network traffic based on IP.We have MRTG server which we use to monitor the network traffic based on the interface of the router.I have a customer who connected to our ISP through serial connectivity.He is having 512Kbps from us...

Is there an upgrade for CiscoWorks that is supported on Windows 2003? If not when will an upgrade be available?

Hello,Maybe this is just a simple problem, but i can't solve it.I have the following problem:I try to connect the 3550 with an 2924 XL, using a trunk with cross cable. I try dot1q both sides because isl is no more possible on the 3550.My router is co...

Cisco 1601 router with integrated csu/dsu spontaneously places the serial1 port into looped mode, if I reload the interface status is up and up, at various intervals of time the interface will show up and up (looped) ,the loop led on the csu/dsu is l...