On some Cisco switches you can confure a range of ports with the range command. Does anyone know how to set the duplex and speed for all ports on a Cat 3500 XL series with one command?
How important to enable such commands which I would hardly see in a "BestPractice Design". Is there any specific environment, where these commandswill be helpful.1)storm-control level for broadcast/multicast/unicast. By default it is disabled. Any...
We have made the catos upgrade of a C6509 and the MSFC, after the reload of the switch, the MSFC does not come up.We try to make a switch console and we cannot control the MSFC. Any idea of what can we do ?
I have Cisco 7513 with STM-1 ATM interface, when I change the MTU size of the interface the router reloads it self.I install an image that support single line card reload and add the command Service single-slot-reload-enable But is dos not work.Here ...
trying to upgrade the cat6500 via ftp.set up an ability ftp server defined the user but ftp fails on the last mile..following is the ftp deb from the cat6500:what may be the issue?GT1#copy ftp://guest:guest@10.129.3.7/s72033-pk9sv-mz.122-18.SXD1.bin ...
Is there a way to tunnel E1/T1 traffic from 1 router to another one ? We have to transport E1 traffic between Newbridges through 2 routers (point to point using).Both routers talk through an 34Mb Wan link (HSSI cards).
Hi all, Can someone see the problem? I am having two issues. 1) Ssh fails to the WAN of my 1711 NAT router. Can you see anything wrong with my acl's that would prevent this? 2) I can only get a response from some web servers on a dmz I created. I get...
Hi,I have a cisco 1721 router with 2 WIC's. Ethernet0 is our SDSL line (primary connection) and Ethernet1 is our ADSL line (secondary connection). Currently all of the traffic flows in/out through Ethernet0. Then there is an aaa.aaa.aaa.1 subnet on t...
I have a catalyst3750 switch with problem high temperature on case surface.C3750 switch have linked connect to 24port in usedand temperature status with sh env all command is ok.but as ethernet link remove, it's not high temperature on case surface.p...
Hello I am having a problem utilizing two WAN interfaces on our Cisco 1760 router (with a 4-port switched WIC Card). Here is a description of our setup (IP addresses have been changed to protect the guilty): interface FastEthernet0/0 description S...
Self-test is pass.But again and again reboot.reboot time is no rule.log message:Switch_B> (enable) sh logNetwork Management Processor (ACTIVE NMP) Log: Reset count: 98 Re-boot History: Oct 20 2004 16:35:31 0, Oct 19 2004 23:19:09 0 ...
Hi everyone,I have implemented a new network with 2-3550s as the L3 core, 3-3750s L2 for the workstations, 1-2970 (new server switch) and a 2924M-XL(old server switch) for the servers. Each of the access switch has links to both the 3550s. I have seg...
I have a problem on a customer site with an Intel(R) PRO/1000MT network card connecting to a 3700 switch.The problems I am encountering are as follow'sWhen using DHCP on a machine it is unable to connect to the Network sometimes, Roaming profiles not...
