Other Network Architecture Subjects

Hello,I want to have 6509 CatOS (8.8.3) and MFSC configured for SSH (VTY/transport input ssh). Then I can't use anymore the command "session 15" from switch as this command seems to be a telnet to the MFSC card.If I enter on MFSC, "transport input te...

We have Catalyst WS-C2950-24. It works like normal.But, if we connect new equipment on FastEthernet port, there is a following message: 00:01:00: ERROR in strata_protected_notify:line935: can't get remote inst pointer That it could be and how of it...

HiI'm currently looking at upgrading my two Cat 6513's from IOS 12.1(11b)E4 to 12.1(23)E. My feature set is SP W/VIP SSH 3DES and I have the following modules installed...Mod Ports Card Type Model Serial No.-...

Hi all ,I want to write an application using C#.Net Can you please recommend a library / API for .Net ?Any other SNMP application Building tip will be welcomed!Thank you!Sharon

hi,i've got some questions again...when you type a " show int xyz " there is a value called reliablility. hopefully it has a value of 255/255 which tells you, that you had a reliability of 100 percent the last 5 min in average.but how is it calculate...

hi,i've got a short question.when you type a "show int x" there is a field called reliability. hopefully it has a value of 255 of 255 which would mean that you had a full realibility of 100 % in average of the last 5 min.but how is it calculated ?err...

Hi NetPro,Currently,i am in vlan 30 (10.30.30.x) and my server farm is segment 200 (10.200.200.x), and from the segment 200 running dhcp pool which is 10.210.210.x .i got no problem to ping and access from segment 30 to segment 200. and i did the rou...

Hi all ! I have a network topo described below: - LAN network connected to SW3550. - SW3550 connected to Cisco3735 by ethernet. - Cisco3725 connected to 2 external ADSL_MODEM to 2 different IPS for backup and loadbalancing purpose. links and routing...

Are there any recommendations on choose a native VLAN? Do you want it to be the VLAN with the most traffic on the switch or the VLAN from which you are going to manage the switch?

My problem is this: On my 6509 native IOS 12.1(11r)E1 when a source host try to reach 2 destination hosts that are on the same subnet the fisrt host is reached ok, and the other host not.When I invoke the traceroute command I see that the 2 routes ar...

I have created a working config for my Model 806 router. I did a copy run to start and I even did a write. I double checked the configs with sh start & sh run.But if I do a reload or if the router looses power and has to reboot the sh start config ...

Did the c3550 support IPv6 or planning support

hello !i have a problem. I have various remotes routers calling in AS5300 using the same username and password. They do well the call but they don't ping and i don't have theirs controls. In spite of it the AS5300 learnt theirs routing routes. When I...

Am I using a fa port or a gi port to enable the mini-rmon not sure Thanks