Other Network Architecture Subjects

I have a wide area network comprising of 2 cisco2600 series routersconneceted by their ethernetport and 12 cisco 1601 and cisco 1721 routers stationed at my remote sitesthings have been workingok for about three years nor.But when I startedconecting ...

Hi,Apparently one cannot have a mac access-group and an IP access-group on the same interface on a 2950 switch. However I have a situation where I need to deny a particular mac address and a tcp port on the same interface (layer 2 and layer 4). Is th...

The ANI server had discovered all the devices initially. But after restarting the ciscoworks server the discovery freezes at 27% everytime, our network consists of both LAN and WAN devices. I have tried to start and stop processes, i have triedto rea...

Hi all,what is a % use of ethernet interface after that the interface is critical and could cause a bottleneck??I have an 10 Mbps interface of my 2600 router that has an average traffic of 5Mbps. Is it critical or not??Thanksmarco

Hi all,i need to know how many Bps pass through the interface tunnel over 2660 router. If i do the show int tunn 0 command i see very few traffic ( i.e 1kbps) but if i look the MRTG traffic map i see about 17K. Why?? There are some limit on bps that...

Hi, We have a 7204 with 2 Gig int cards. Only OSPF is enabled with NPE-400 CPU and 128 RAM config.In the spec sheet it says NPE-400 scales up to 400kpps. What would be the max throughput one can acheive on those boxes. we are currently at 50Mbps and ...

I use frame relay subinterfaces (PVCs) to connect to small remote offices. I also use Whats UP Gold to monitor devices. My question is this: Do the Cisco MIBs support reporting of stats for FR subinterfaces, or will it report on the major interface o...

I can't logon as enable mode for the switch 1900. Since I am using the same tacac server. I got no problem to access other switches. Even though, I have reboot the switch. The problem still there. Need help!

HiI have a 2900 Series Switch, and would like to setup the following. I think I will require a router to do this, but would like to confirm this.I have a backup server that is connected to the switch on port 1. I have about 20 other servers that are ...

Please excuse my near-total Cisco ignorance...I have inherited a 2950-12 and plan to use in our charity's 4-person office. What would be extremely useful would be to limit the bandwidth available to each person as we have just a 1Mb internet connecti...

I am trying to get the SDM of a 1721 router working, that has a WIC card installed. I have connected the light blue Console cable into the serial port of a laptop and the other end into the back of the router marked Console. However whenever I open I...

Here is scenario:Router has couple of outside interfaces and also there are 3 static default routes to outsides with different metrics:1) Fa0 (metric 30)2) Tunnel0, GRE over Fa0 (metric 20)3) Tunnel1, GRE over Fa0 (metric 10)The main idea to use lin...

thanks!

I would like more info configuring a Cisco 2600I'm buying one which will act as RAS box.Therefore will have Analog/ISDN modules installed.If i could have more info on how to install/configure/etc.any other resources would be gretly apprciated

Hi all,The router went into ROMMON mode loaded the image through xmodem and rebooted the router but the router again went into ROMMON mode.While issuing the command dir flash: the following error message was received "Bad device name" please advise...