Other Network Architecture Subjects

Hi,It is required to integrate CW LMS with crystal reports. Can anybody tell me what is the procedure fro this. I have installed the Crystal reports and the server is recognising the ani.db & rme.db in the same server. While trying to connect it does...

Cisco 6509 CATOS 6.3(7)I have etherchannel configured on dot1q (desirable)trunk on the switch. When I change the etherchannel mode from "on" to "desirable" on one side of the trunk, the port was reset. Is there any workaround to avoid this port reset...

I have a cisco 2610xm with ios 12.2.8-T5 and a nm-4b-s/t 4 port isdn bri card with a bri attached to each port. The problem is that i cannot get ppp multilink to bring up more than 4 channels out of the possible 8. Is this a known limitation with ppp...

Hi,We have a cisco 7200 which forms adj with ospf neighbors (extreme network summit switches).Everyting was fine with IOS 12.0(3)T but when we upgraded to 12.3(4)T. all adj went down. To solve to problem we disableld the MD5 message digest for OSPF a...

Hi All, i was upgrading the IOS for 6506 MSFS 2 card. after uploading the IOS the switch went into boot loader. can anybody tell me how to revert back.thanks in advancergds,ciscobuddy

Hello,On a catalyst 6500, with SRM definition, we have the secondary MSFC not having the "sh run" synchronized.I was told some time ago that using 802.1X on the sup-card (catos) isn't compatible with SRM definition on the MSFC (IOS) but today I find ...

Hiya,Im am just looking at these two and wondering what are the differences between them - which should i use to control access to the network configurations etc ??ThanksEd

I am trying to determine the best method for maintaining the RME syslog so that it does not cause capacity or performance problems, but so that I can still look at the last 14 days worth of data.I have tried using the Log Rotation (logrot) program, b...

Hello all, We have a fairly small network (500 nodes) being run by a Catalyst 3550 and a bunch of 2950s. They are seperated via VLAN's presently with each being on it's own subnet.Now, we just got in this "Fluke Networks LANMap" add-on to Visio (w...

Hi,I'm looking for a config for bonding 10 channels on ISDN between two sites.This will be used as backup and we want 10 channels 640k always and to be up imediately when primary link fails and dials remoteA link or config would be great.thanksA

If I already had a T1 circuit (with external CSU/DSU) in my office, can I connect to a Cisco router if it only have a serial interface without any T1 controller ? If so, what kind of encapsulation should I set on the router ?Many thanksalec

Does anyone know the procedure upgrading software for this module?9 Gigabit Ethernet ports module (WS-X5410)Thank youDong

I'm using Hotspot 1.0 bulid 1. My clients are connected via wireless network. AP are connected to switch and the switch to the Hotspot.Now I'm having few issues:1) What is the mechanism for timing out clients which is connected to the AP? 2) One of ...