Other Network Architecture Subjects

We are having an odd issue in which a 2950 we have plugged into a 6509 is inaccessible. A reboot was done and after it was rebooted, the management interface on vlan999 is inaccessible via telnet or ping. If we move the management interface to a diff...

R1 R2 R3 R4 connect over FRR1 serial 0.1 to R2 serial 0(Point-to-Point), run rip ver1 between them.R1 serial 0.2 to R3(s0),R4(s0) (multipoint), run ospf between them.I can ping from R1 to R2, R3, R4After run OSPF and RIP, everything is ok. redistrib...

The switch load LED's on the WS-X6K-SUP2-2GE supervisor module do not light up on our CAT6506. When i contacted our re-seller they the following "Basically I don't believe that you have an issue with faulty LED's. As I understand it the LED's will ...

I am wanting to see if there is any infomation available for setting up ppoe on a 2514 router running the newest IOS. I have heard this can be done but i cannot find much documentation on it. Any help with this would be greatly appriciated. Adam Howa...

I've been digging for a fast ethernet module for a 2620XM and only find discontinued items.Anyone know of a current supported module?

While buying a Cisco Router which should be capable of handling multiple T1 or T3 lines what should be considered for good performance, like the processing speed,cpu. what is the ideal hardware what will suffice multiple t1 or t3 connections with BGP...

Currently have 3 nm-4t's installed on a 3640, intention is to utilise 11 of these with 2meg leased lines, however when leased line 9 was connected this caused drops and carrier transitions on other interfaces. IOS 11.1(20)AA

Does anyone know of any issues with a SPAN port flapping when activating it to a Sniffer, have tried a few Sniffers also. I am getting the attached messages:Jan 16 13:04:19 XXXXXXXXXX 2004 Jan 16 13:04:19 CST -06:00 %SYS-5-SPAN_CFGSTATECHG:local span...

I would like to integrate an uBR924 into my private network at home.Nothing fancy,just uBR924 configured as a plain old cable-modem!! I already have a 1720 RTR for my routing. Problem is, whenever I try to configure the uBR924 for bridging, during bo...

Hi,Between the following 2 configuration of a hub and spoke frame relay, what are the pro and cons???Eg 1interface serial 0encapsulation frame-relayinterface serial 0.1 point-to-pointip address 10.1.1.1 255.255.255.0frame-relay interface dlci 100inte...

Hello.What is the maximum number of AS #s that can be included in the AS_PATH Attribute of a particular route ?In the RFC it states:"Total Path Attribute Length: This 2-octet unsigned integer indicates the total length of the Path Attributes field in...

Greetings!Would anyone know how I might configure an interface on the 2948 so I might capture traffic with a protocol analyzer? I was told I could span ports but I cannot find a way to do this. I tried using RMON but I think I need an SNMP agent to...

hi,if we have say 2 vlans (vlanA, vlanB) on a layer 3 switch connected to the internet, how is dns server configured on the switch.vlanA,vlanB -------router-----internetipA-ip address of vlan AipB-ip address of vlan BipDNS-ip address of DNS server on...