Now we have 3662 router with 6 NM slots, but as we want to make new central office site, we are going to buy 2 routers with minimum 6, preferable 8 modules and by its performance 3700 serie is enough.Does Cisco plan to begin producton of 3765 or 3785...
Hi,When trying to update switches configuration from RME, I receive a partial failure message.When checking in the "archive status", I found that the startup was successfully updated but the VLAN failed for the following reason: "TFTP not running on ...
Here is the setup:I have 2 LANs with 4 routers and many remote offices. Router A is on LAN1 connected to one side of the outsourced WAN via s0/0. Router B is on LAN1 connected to router C that is on LAN2 via a point-to-point link. Router D is on L...
I have read many documents on CCO regarding QoS on various platforms but I would like a definative guide/recommendation for an AVVID network - Cisco CallManagers/IP Telephony/VoIP, Video and Data. AutoQoS seems to set various things up but it just d...
During the diagnosting of the IDSM-2 in my cisco Catalyst 6500 switch i receive the follwoing error message:%ONLINE-SP-6-INITFAIL: Module 5: Failed to synchronize Port asicany help would be greatly appreciated
Hi everybody.We have a situation where in we want to restrict a paricular ip-address and mac-address combination gaining access to the network. The network comprises of3548 XL(IOS 12.(5).WC5) at user end, which gets connected to a 4006 with sup-ii+42...
Can you please tell me what are the physicaladdresses or mac-addresses for the 50 ports of switch 2948G?i need topopulate values in RFC1213-MIB and IF-MIB to simulate the agent.i gotthis infoCompare:c2948-dc> (enable) show moduleMod Slot Ports Module...
Dear all,In Resource-Manager | Administration | Inventory | View Check Results - I have some devices listed as "Write Community - INCORRECT".These devices use a write community other than default.When I change the community-write-string ("change Attr...
I have a one 2611 and two 2621 routers that all the config-registers have a value of 0x3922 and when I change it to either 0x2102 or 0x2142 they change to a different 3900 value. The second problem I encountered was that in rom I can't use the tftdnl...
hi allit is possible to save ios versions from router and switches with ciscoworks2000 ?? running config and startup config is no problem !thanks in advance
Hi All, I had saw some post about 3550 voice vlan in this forum. Many people said that the voice vlan just can be configured in trunk mode as follow: int f0/1 mls qos trust cos switchport trunk encap dot1q switchport mode trunk switchport trunk nativ...
I'm trying to copy an IOS image (about 40meg) to Disk0: (Compaq pcmcia flasy) on the Sup720 on Cat60xx.I like to know the various options available for copying a large image to compaq flash.
Hi,I´d Like to know if any of the switches 2950 can do routing. At this time I have one 2950G 24 E1 with enhanced image, but I dont know if I can do the switch routes maybe changing the IOS or something.Thanks in advancedEF
