Other Network Architecture Subjects

We've recently implented SecurID authentication and as part of this added the command autocommand ppp negotiation to our line configs. We have 6 - line 65 70. However I'm noticing, for no reason I can see, that after a few days the config alters with...

I'm getting ready to install a Cisco 2621XM router and have a general question about it's auto shutdown capabilities in event of a power loss. It will be on a UPS but I was wondering if there was a way to configure it for a 'gentle' shutdown if powe...

Hello , Why Cisco Works cannot monitor private addresses ? When i try to start monitoring i see the following message: Status 11018 Invalid Address. Is there a way to use Cisco works with private addresses ? Thanks fo supprting me

Folks,I'm looking for a decent isdn simluator, i want to connect two 1721s & simulate an isdn connection.Any ideas where i could get such a piece of kit?thanks

We are currently running c3620-is-mz.122-12a in the 3620 routers which have the IMA module in them and they work fine (with the exception that I sure wish the IOS would support CBR on this module). Due to the IPv4 bug we attempted to upgrade the rout...

We have CAT 3500 XL switches running IOS 12.0(5.2) XU - What is the highest release that these switches will support? I seem to have lost my compass on the IOS roadmap.

Does anyone knows the maximum performance of the FEIP and the FEIP2-DSW on the 7500. I'm trying to compare the performace of the PA2FETX and the FEIPs. Does anyone has any info or links.Thank you

Is the Catalyst 6000 Supervisor IOS affected by the recently discovered vulerability outlined in the following document?http://www.cisco.com/warp/public/707/cisco-sa-20030717-blocked.shtml I noticed that in the main IOS download area, the vulnerable ...

Hi,I have been trying to find Technical Specs for WIC-1B-U-V2 at CCO. My queries and searches didnt yeild any results. Would greatly appreciate if you could help me find the tech specs for WIC-1B-U-V2.Thank you,Ravinda - ravindam@sg.ibm.com

Currently, all my computers are in one vlan pointing to my router for their default gateway (i.e. 172.16.0.1 /16) Correct me if I am wrong, but after I set up Vlans and assign ports to them, I will need to make sure that the default-gateway of the no...

Hi all,we have a small 837 that had all files/memories erased by its previous ownerand while trying to recover it they uploaded the wrong ROMMON file. (I think it was a 827 ROMMON) Nowwhen restarting it says it is an unkown device with 4MB of memory ...

I needed to upgrade my 2 x MSFC2's to c6msfc2-dsv-mz.121-19.E1.bin from c6msfc2-is-mz.121-3a.E4.I copied the new image to sup-slot0:, added the boot system variable and reset the MSFC's from CatOS - they booted the new image from sup-slot0: succesful...

Sir,My router GSR popped out warning message Continually:"%LC-3-PSALOADSHARE: MPLS loadsharing inconsistency for 219.72.0.0/16 ti 1 ld 16"I have no idea about it. And per Cisco Error message decode result, there are 2 solution about it:1) Recommended...

I currently have a Cisco 677 in a default configuration where theserver is at 192.168.1.2 and the other machines on the LAN get to theInternet via NAT. We now have been assigned another IP set (4 IPs, 1allocateable to a machine). The new IP was neede...