How to calculate the port cost /port vlan cost over the etherchannel which consist of 2, 4 and 8 port in the group?
How to calculate the port cost /port vlan cost over the etherchannel which consist of 2, 4 and 8 port in the group?
Hi, are there any patches required for CiscoWorks LMS 5th Edition? If there are patches required, what are those. Maybe a website stating the patches would be helpful.Thanks,Matthew
hi,Can any one tell me Y is the status of DSR=down.when as i am able to ping the ip of the other end ip sucessfully.(DCD=up DSR=down DTR=up RTS=up CTS=up).Router # sh int s3/2Serial3/2 is up, line protocol is up Hardware is M8T-V.35 MTU 1500 by...
I've noticed tclsh/tclquit commands on a 7507 running 12.2(10) IOS. What kind of things can I do using Tcl scripting on a router? I searched these words on Cisco.com and every item found was about something involving voice applications.Regards.
Hi,We have a two catalyst 4000 IOS ver 12.1(8a) connected to two 7204 router. The two routers and switches are connected in a full mesh configuration. To reach a destination x.x.x.x I can see four equal cost paths in the switch routing table. Now how...
I have a need to simulate a customer that has a link to the internet, and that is doing NAT for some testing. I have a Cisco 804 and an ISDN dialup connection to the internet and I was at first thinking I might be able to use that, but now I'm thinki...
After installing ISC 3.0 apparently without any problem, when I reboot the workstation I am not able to launch ISC administration browser.If I use http://host_name:port/isc the browser sends me the following message "Netscape is unable to locate the ...
Hi,Is there away to configure traffic to load balance/increase bandwith between two different ISPs without using BGP? Both routers are 2600's and I don't know that they have enought horsepower to support BGP.Thanks,Frank
I try to configure Asymetric Link based on Cisco Mobile Networks-Asymetric Link document. the first problem I have was the IOS version.. I download the recomended release but this release have some bug´s so I download the corrected release...(c2600-i...
Howdy,First, I have a couple of 678 DSL routers that run the Broadband Operating System, and I'm wondering if they are vulnerable to the IOS IPv4 vulnerability disclosed recently.Second, I have a 1600 series WAN router running IOS. I am assuming tha...
Hello,I'm a beginner on Cisco so I have a stupid question maybe.Can I use access-lists to redirect certain traffic (for example www) to a computer in my internal LAN? I have a 1605 router as connection to the Internet. I want to setup a webserver, ho...
Is there a way to have a inside interface with two IP address ( 10.25.0.1 and 10.18.0.1 ) do a static NAT between two inside hosts ( 10.25.0.100 -> 10.18.0.100 ) or do I have to have a second interaface? I want to be able to ping 10.25.0.10 and have...
Is there a method to archive the vlan.dat file for recovery. If so is there a recovery procedure for using the archived file if the original is corrupted or deleted. Where does the vlan.dat file reside in the file structure on a 6513?
I want to know what version I should upgrade to from 12.2(8)T5 to be safe from the recent IOS interface blocking vulnerability.Please advise.-CC
My company has bought two adsl lines from a isp for accessing the Internet.I have a 1721 router and two wic-1adsl cards.Now I want to use these lines increasing the bandwidth,but I don't like to use policy-based routing by dividing the inside net...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
08-07-2024 06:15 AM | ||
07-17-2024 11:08 AM | ||
07-17-2024 06:07 AM | ||
05-29-2024 04:52 AM | ||
02-14-2024 04:00 AM |