Other Network Architecture Subjects

Hi,,, I have problems with de Callback process. The debug ppp cbcp show the messages:01:24:40: As70 MCB: Initialize01:24:40: As70 MCB: Flush01:24:40: As70 MCB: Start01:24:40: As70 MCB: Callback not authorized for this user ale01:24:40: As70 MCB: New...

We have a 2950T switch connected to 3550 12T switch.On the 2950T switch the 100BT ports are used for uplinks from other switches catalyst 2924xl. PC's on the switch FTP to server on the 3550. For a get they have speeds of 5000-6000 bytes per seconds...

Hi all,I'm trying to figure out a way of allocating/prioritising bandwidth on a router that connects our network to the Internet. I’d like to for example give 60% of the bandwidth to HTTP/HTTPS, 20% to a VPN link, and the rest allocated on a fifo bas...

Hi,Can someone give details of ports used by Kaaza software.TIAMurthy.

Hi,I've read a few of the comments about multi-homing an Ethernet interface, but I can't seem to get to the bottom of the issue that I'm having. I'm attempting to add a third IP address to my Ethernet0/0 interface. In my config I've the following:i...

HiI am trying to implement load balance between two firewall and found this diagram from cisco website. I just wonder why L2 is needed. What is it for?L4-----L2----F/W----L2----L4 | \ / \ / | | \/ ...

I am looking at a proposal that will use a 3550-24-EMI switch at the core, which in turn will connect up to twenty remote sites (over 10mb LES circuits). Each of these remote sites will have maybe two or three vlans. at each remote site, I can eit...

Hi all,For dial up users to the Cisco router, I can use local authentication command "username xxx password xxx", TACACS+, RADIUS. Are there other methods? There are only for 8 dial up users, I would think local authentication will be the easiest a...

I did not set up any etherchannels on my 6509. However, the output of "show config all" displays the following:#port channelset port channel 1/1-2 488set port channel 2/1-4 489set port channel 2/5-8 490set port channel 2/9-12 491set port channel 2/1...

Here is the scenarioWe have 2 LAN's connected via DSL modems over an ISDN line.Just got 2 2620's with one ethernet and one serial interface. I want to roll over slowly to the new scheme as I have some apps to test and a new NT domain to create and I'...

I have a 6509 and DFM is reporting insufficient memory. The free memory percent value is 12% and the threshold is 15%.