I want to configure Mobile IP on Cisco routers 2500 IOS 12.1(6), I´m using eigrp for routing, but when I try to activate Mobile IP, doesn´t work, the IOS answer "Unknow routing protocol" Why it doesnt work????regardsghaces
I've got a weird situation that I can't figure out. I have a 2611 with 2 ethernet interfaces. e0/0 is facing my access network via an RFC1483 bridged DSL service. e1/1 is facing my LAN. When I look at the arp table on the 2611, I see thousands of...
Working with a client to develop an upgraded networking infrastructure design. They have concerns regarding the network configuration proposed. They are going to have a Cisco 4507 core switch with either Cisco 3550 or 2950G closet switches.The issue ...
I have setup the following 1720 router for Async (Pstn) callback to use with a windows PC dial-in. Although I followed all the steps mentioned in the Cisco configuration example: http://www.cisco.com/en/US/tech/tk801/tk36/technologies_configuration_e...
Hello!I know the MIB for 802.1w/s is not ready. The goal is to track VLAN to instance mapping, STP states, and so on.When will Campus Manager support management ofswitched networks that implement RSTP/MST? Thanks, Ivan.
I have setup the following 1720 router for Async (Pstn) callback to use with a windows PC dial-in.Although I followed all the steps mentioned in the Cisco configuration example:http://www.cisco.com/en/US/tech/tk801/tk36/technologies_configuration_exa...
We currently have a CAT4 with a Supervisor IV Engine running v12.1.13EW of the IOS. Would love to be using NAT or PAT, but no such luck. What other options are available without having to buy "more" hardware? Are there any plans to include NAT/PAT...
Hi ,channel gets disabled with the following error following error ' %SPANTREE-2-CHNMISCFG: STP loop - channel 2/5-12 is disabled in vlan/instance 199 ' Setup is ======> We have 2950----->3550------>6509 setup Two uplinks from 2950's connect to ...
I want config vlan trunk between 2950G-48 and 2950-24.The config like this:sw1:....interface FastEthernet0/1 switchport mode trunk no ip address....sw2:....interface FastEthernet0/1 switchport mode trunk no ip address....The trunk ports can up, and t...
We have network with star topology and about 15 switches. There are two 3508G modular switches at the top. Switches are connected with fiber on gigaports. Once in a few days happens, that network crashes for about 20 - 30 minutes. LED's on switches s...
I am designing a GIGE network that is interfacing with an ATM device that is connected to an OC48. My problem is what can Cisco offer in my design to combat the problem of a gig lan then going out of an OC12 pipe. This could be a bottle neck with a...
Hi and sorry for a newbie type question !I am dialing OUT from a 3640 router with MICA-6DM modems and am trying to connect to a service running PPP with PAP authentication.I can access this service from my laptop using Windows DUN.The router/modem di...
What should the minimum requirements be for someone to be able to manage the CiscoSecure ACS system for a major corporation that relies on the network for revenue streams and critical customer support?Thanks.
