Using meraki MX68 just as gateway for routing and monitoring (no VPN)I am deploying an Starlink internet service in a remote location. In the first stage, we want to test it and monitor it to be able to measure its health and stability.In such scenar...
Any other people using the ELK stack for their network logging infrastructure happen to have a decently complete grok pattern file for Cisco network equipment? As a bonus, does anyone have a set of patterns that support ECS (Elastic Common Schema)?
Hi there,Thanks for readingI'm trying to set up a PRIV SNMPv3 config on a C9200 running 17.6.3 to allow connection to our Solarwinds server. Debugging leads with an "Unknown Engine ID" error. I'm able to see the local engine ID but suspect that I n...
Hello, good days, someone could shed light on a problem I have with 8 SGE-2010, I want to set them up on standalone mode, but out of 8SGE-2010 I have 3 that I can't connect to, and when I connect to the console, I get a line of commands in DEBUG, and...
Hello.SYMPTOM:-On enterprise ethernet LAN, workstation connects first-time through ASA-5525 with sftp to remote vendor. No symptom.-On enterprise ethernet LAN, workstation connects second-time through ASA-5525 with sftp to remote vendor. Symptom is t...
Hello all,
I am trying to determine potential End of Sale and End of Life for supervisor engine 8-E.To my surprise, I did not find any EoL reference for SUP 8.Could you please advise if you are aware of any EoL announcement related to SUP 8? (WS-X45-...
hi ,
we have two nexus switch in vpc and 5 access 2960 switch in stack. i am trying to config dhcp on catalyst 2960 and dhcp relay under L3 vlan on both nexus. it's not working.
Hi, I have a network I need to set up for a client. 1 Firewall and 2 Cisco C1000. On the Cisco C1000, I have created 5 VLANs (VLAN10,20,30,40,50 for Management, Data, Servers, Wireless, and Printers). Each VLAN is an SVI with the following configurat...
Hi, When I try to download latest packet tracer version 7.3 the download interrupts with an error message that the file is 'read-only'. The download has to be aborted. I have checked/un-checked the read-only properties option on the file without luc...
Hi everyone, I tried to read the question on the net but it seems very confusing and not precise.I have two hp computers a laptop and a desktop; both NICs from the information taken from the adapter properties, are both 1 Gbps.On both, I connected a ...
Hello folks,
We are checking max MTU we can achieve .. As you can see, we can configure the MTU under interface to be 9000 while only 1552 through system MTU.What's the different between both?, Is there anyway to upgrade "system MTU" to accept jumb...
hello,I need to know which IP/device is connecetd to a cisco Switch port.I can get the mac-address of that switch port using sh mac-add command, but with the mac address how can i find that which ip belongs to this mac.is there way i can do this, i k...
Hello,I have a Mikrotik hAP ac³ router configured in parallel to a Cisco ASA 5525. The Mikrotik has a VPN tunnel up and passing traffic. It was installed to alleviate traffic off of the ASA. Only if I source the ping from the bridge (LAN side) interf...
Hi, I am working on CML and I would like to enable performance-measurement in segment routing traffic-engineering policy on XRv9000 routers: segment-routing
traffic-eng
policy TEST
color 30 end-point ipv4 4.4.4.4
performance-measurement...
