Other Network Architecture Subjects

Hi All,The random-detect command, for example:random-detect precedence 0 32 256 100 I had seen some manual but I still can not understand what the parameter above "32 256 1000" for, and how to calculate it. Can any body give me a hand? Thank You!Best...

at first ,i think could use network cmd ,but give it a second thought , i think BGP router uses the netwok cmd populate BGP routes to other BGP router,so cant use this cmd here so ,now i dont know how can i do it

Our office need to set up the network for remote dialup access. For some reason we can only use a E1 line to achive the remote access mission, The remote office use the analog line to dialin. Cause it need too much time toplace an order for the cisc...

Here is the output of a sh spantree active : Why there are two different cost of 19 and 100 ? I noticed that 100 is connected to 10 MB/ half duplex devices, where the 19 is connected to 100MB full duplex. Why ?Any input is highly appreciated ?Thanks...

Hi, i have a router Cisco 2621 with two fastethernet port. Some days a go syslog router show me:02-19-2003 09:03:21 Local7.Error XX.XX.XX.XX 14546: Feb 19 09:05:09.998 : %AMDP2_FE-3-RXOVERFLO: FastEthernet0/1 Rx FIFO Overflowxx.xx.xx.xx is ip direct...

Anybody have sample config for this card? The card will be connected to four locations.Thnx

I need to control traffic through 6509. please provide assistance. thanks.

Hi, I would like to apply in a more clear manner policies with our upstream ISP tiers, i need more info to evalute how can conmunities help me in this goal. i would appreciate any link with info regarding bgp conmunities use. Thanks ahead!

We are trying to install an FSM to our 6509 Using the 7.5.1 software in Hybrid mode we are unable to get the vlan to communicate to the msfc2 for the inside interface. Also having problems getting documentation.

I apologize upfront but time is of the essence and I am a bit confused about this old router I found at my company. I am not to familar with these commands and needed to configure the router for basic internet connectivity. I have all relavant inform...

i am about to install openview on our network and since i have to lisence the software based on the ip address i wanted to know the best segment to put this device on. do i put it on vlan 1 which is also the native vlan for the trunks running back to...

Greetings,I am currently trying to configure manual bindings on a router using DHCP. Configuring DHCP is relatively easy and painless, but how do you get the DHCP server on the router to statically assign an IP based on MAC address? I located some do...

We are trying to use Cisco Secure to AAA our CW users. I have succesfully authenticated, but am trying to figure out the following:· We have confirmed that CW can Authenticate to the Cisco Secure server.· When the user authenticates using their ID, ...

I have a router (IOS 12.1(16)) with an ISDN PRI receiving calls from remote routers. I want my router to send the configured ppp chap hostname during the ppp authentication phase, not its router name.However, using the configuration below, my router...