Other Network Architecture Subjects

We have a CISCO Catalyst 2948 switch and a Sun E3500. Is it possible to connect a Sun Gigabit Ethernet 2.0 P/N - X1140A (1000Base-SX) to a 1000Base-FX GBIC Module on a Cisco Catalyst 2948 Switch? Is there a special cable, interface .... required for ...

Where can I found the 12000 line cards(POS, ATM) memory requirements. I could not found them on the release notes for 12.0(23)S.

Hi,I have a router with the this message "%OSPF-4-BADLSATYPE", and I dont't know what's the problem, the only difference I've seen is when I execute "show ip ospf nei det", then appears the option 66.I only know two option, 0 when there is a stub are...

I know current password but want to change it and dont know the commands any help is appreciated

on my CAT 4006 I have my RSM in slot 2 and my sup II is in slot 1. When I do a 'show port channel statistics' command the output I'm getting looks like my 2/1-2 channel is not exchanging the PAgProtocol? Does this mean the 2 Gig ports are not prope...

i know the existing password what must i do to change it?

I have a new Frame Relay cloud that I need to connect five remote offices to my home office. I am using Cisco 1720 routers to accomplish this task.I have setup one remote site already using subinterface settings. The problem I am having is that I hav...

Any help on changing the password from one to another would be helpful thanks

We are in the preparation phase, getting ready to implement a new Catalyst 4006 CORE Switch, with 1 - WS-X4448-GB-RJ45 module, 1 - WS-4148-RJ module, 2 - WS-X4306-GB modules and a Supervisor III Module.I would like to find some GOOD references for im...

Trying to upgrade 3640 IOS from IP (c3640-i-mz.122-5d) to IP Plus. Router has 32mb memory, a 1FE2W network mod and a WIC-1DSU-T1 card. Release notes say I have enough memory, however when I upgraded via tftp with c3640-is-mz.121-5 or c3640-is-mz.120-...

To install Ciscoworks 2000 LMS and RWAN on a Solaris system, what are the OS requirement ? Below are the questions.1) What are the files name require? How big is the mount points recommended and what is the name of the preferred mount points?2) What ...

Hi,Does anybody knows how can I transport 2 vlans from a catalyst 2950 switch connected via FO to another catalyst 2900XL and then from the catalyst 2900XL to a windows 2000 router with 2 nics that acts as a router.Any documentation, tip, clue or any...

Hi i have a router with 3640 with c3640-is-mz.121-2.T.bin IOS, it work fine for video H.323, voIP and data. But in the LAN i have vlan with ISL and switch 3524XL and principal 6506Catalyst, but my IOS of the router it don´t support virtual ethernet i...