Does anyone have problems with discoveries starting and just stopping right in the middle? Also does anyone know if Campus Manager is going to support MSFC2's with 12.1(13)E code?
I want to order the Dell 3248 and connect it via fiber to a GBIC port on a 6500. Has anyone done this yet? Also, if you have, do you happen to be using 802.1q for your VLAN setup. We havent got the time or money to test so I am hoping someone can t...
I have a 2511 RJ that we are setting up. We are using TACACS+. Will be moving to RADIUS later. The problem is that when a user dial up, they get a windows 733 error, babling about inability to get a negotiated protocol.NAS config is as follows:ver...
I am looking for some direction / information on QoS configuration for Packet over Sonet Interfaces on the flexwan module for the 6509 catalyst. I have not seen much in the documentation.thanksDave
Hi,I am trying to connect two 1600's together using PPP over X25 on ISDN dchannel using the AODI method. The following two configs are the client and server running configs of each router (client first). I keep getting this error (Pending on AODI dia...
Every time the CW2K server is restarted, Campus Manager starts a discovery and brings down the serial links of our network for about 20 sec. On analysis, we found that the links may not actually reset but that the ANI server is sending massive amount...
I have one Cisco 4500 with 6 Ethernet, and 8 serial port. It has only 32mb dram. (2*16mb). Now I wan to run BGP in this router. So for that I need min of 128mb memory. It has only two memory slots. Is it possible to upgrade that to 128mb. Will it tak...
Hi,Is there a way to allow a user to have access to the previleged execution level with out being able to go to the configuration level.In other words i need the user to have access to all the commands available in the previleged exec level with out...
Hi, we had a problem when we connect our NAS ( 5800) with pri from telecome company, the controller is always flapping, even we made a loop back tests to verify pysical connectivity and we found that the connection is up and no flapping, when we conn...
I have one Cisco 4500 with 8 serial port and 6 Ethernet port. From the Ser0 and Ser1 I have two connectivity to my upstream provider. But one is of 2MB and other is of 1MBSee the configuration of 2 of LAN interfaces and ser0, and ser1 interfaces...
Hello, following error mesgs are coming on 6506 which is my backbone , running 20 vlan's. please guide me1. ) Nov 18 12:08:14: %STANDBY-3-DUPADDR: Duplicate address 10.3.1.2 on Vlan1, sourced by 0000.0c07.ac012. )Nov 18 15:39:28: %OSPF-5-ADJCHG: Pro...
hello, I have advertise the network 10.0.0.0 in OSPF, i am getting whole routes of my company. now i want to advertise only 10.3.0.0 whish is my Intranet network. following is my conf.( At present )router ospf 1 log-adjacency-changes network 10.0....
