Other Network Architecture Subjects

I want to setup a second 7206, configured exactly the same as my current. Right now, I have a dual - ds3 card with two providers coming in. If I was to setup the second 7206 and I want to use HSRP..how do I go about making both DS3's span to both r...

What is a rely?

I would like to automate the process of adding devices into the Ciscoview master Device list. The input for the file will be a CSV file. An option exists on the CiscoView Server (admin panel) to import devices via a CSV file. Does anyone know how to ...

I am trying to set up an 802 ISDN router using the fast-step utility. It sets everything up but will not dial out or route to anything. It hands out DHCP addresses and I can ping its address but no dial-out. There are no other screens in the fast-ste...

Does full-duplexing and half-duplexing modes exist on coax and fiber as well as UTP?

When I do the above command I get the folowing:P 0.0.0.0/0, 0 successors, FD is Inaccessible, tag is 325 via 151.131.10.2 (943872/943616), Vlan10What does this mean. The entry is for the default route and the default routs is not installed i...

I am installing a campus network with 2 cat 4006 (sup III) and 2 cat 6513 with native IOS. I will be configuring L3 between the switches and will be running VoIP - I need to configure QoS , prioritise Voice , Mail and SAP. Is there a basic config tha...

Are there any know issues with configuring management and native vlans in the same broadcast domain?ieinterface sc0 6 10.132.6.6 255.255.255.0set vlan 6set port (all 10/100) 6Thank you

Can the same host address (148.92.24.206) be used in NAT Pool and Static NAT configuration?Router-configuration!interface FastEthernet0/0 description 100MB LAN ip address 148.92.158.189 255.255.255.0 ip nat inside!interface Serial0/0.100 point-to-po...

Hi !The Power OK LED on the I/O controller module of our 7204 VXR is amber when powered on. The power supply is fine but none of the other LEDs on any of the other modules are on. Looks to me like we'll have to replace the I/O controller. Help !! Tha...

Has anyone tried to manually do the integration of CW200 and NetView 7.1.3 on LINUX? Cisco does not support CW200 on Linux even though I am only using a browser from Linux to access CW2000. Has anyone tried to hack the import so at least the MIBs, TR...

I have a 2600 router with internal csu/dsu T1 WIC:If I have a T1 line coming in from Telco which is giving me Voice on the first 12 channels and Data on channels 13-16. If for some reason I don't want to split the T1 and simply ignore the Voice chan...

Hello,I'm encountering an issue where SSH connections from the outside coming into our network will timeout after a few minutes. Keepalives are enabled, and I know it's not the firewall because SSH connections going between networks connected throug...

I have a 3640 router that has 1 inside interface and 2 outside WAN interfaces. One outside goes to the internet and the other to a private government intranet. My problem is I need to use NAT to convert my internal private range to the appropriate ...