Other Network Architecture Subjects

When using the config maker software to setup my routers the ip address and subnet we are currently using error with subnet is inconsistent with mask. I was able to manualy set the ip address to this through the console. The problem I have is that I...

How can I connect and configure my 2610 (with just one ethernet, no WIC) router to the adsl modem running PPPoe? and doing NAT for my LAN?Internet------->adsl modem------->2610 router--(NAT)---->1900 switch----->LAN. Thanks,

Looking for a list of catalyst switches that support snmp v3

What does soft errors or hard errors mean when i use the command "show controllers token"? And what are the two main types of soft errors that an internal controller can count? Why?

Can I use NAT on a IP Unnumbered interface?Have an Internet Router from UUnet where Serial 0 is using IP unnumbered E0. Will this cause a problem with NAT?thanks,andrew

We have CW2000 LMS 1.1 ( RME 3.3, Cisco View 5.3) , we have problems with the performance of the Application ( only CW2000 runs on this machine). Could somebody inform what will be the advantage to upgrade to LMS 2.x . Thanks

I just installed CWW60. on a new win2k server. Installed the patch that came with, STILL getting that darn message "Cannot Launch CiscoView in browser, Please Grant Permission"......VERY frustrating. Please help, this Patch does NOT seem to be work...

What maximum number ov VCs, that i can terminate on NI-2 card to proceed IP traffic ?

Hi all,I intend to configure Frame Relay over ISDN for backup purpose, but I have a very vague idea of this issue, for example, what series of Cisco router, and some sample configurations... If anyone has ever configured some thing like that, please ...

I have a 7204 that is simply bridging between two FastEthernet ports. I would like to use ACLs to protect devices on one of the ports. However, I want to protect TCP services (e.g. stop telnet & ftp). Is this possible?

We are seeing the following message on our switch , is this a hardware problem or should switch be reloaded . Can not find this message in any of the message guides that we have or online . %SYS-4-P2_WARN: 1/Astro(2/4) - timeout is persisting

i have the following situation occuring in my lab:using 2 x 7206VXR's - both with IOS 12.2(10b)The 7206VXR router is connected into an EIGRP network, and has eBGP peer with an 'internet router', and an eBGP peer with a second 7206VXR that is also con...

I have some questions about setting up an snmp config.These are probably really basic questions but I just wantedto get some clarification for my own benefit. I tried looking up the first 2 commands using the TAC command toollook up and didn't get a...

Why would the CLI not be available on 1900 switch(option K) when you telnet into the device?

In Cisco Works 2000, NMIDB has been loaded at 10.0.059, but the comparison indicates that CCO is at version 10.0.058. I have heard that 10.0.060 is actually available, but I cannot get it through Cisco Works or find it in the software downloads on th...