Other Network Architecture Subjects

I have two routers with an ethernet interface and a t1 between them.I have a stream server connected to router A's ethernet and a receiver connected to router B's ethernet. In a normal situation I would specify IP PIM *some*-mode on the ethernet inte...

Hello , I have a customer that has a cat4000 with the sup III engine and they would like a web management interface for it (other than the skimpy http server) , is there management software available like view for catOS , but for IOS ?thanks

I have a 3600 router with two ethernet interfaces. I have an aDSL modem connected to e0/0 on the 3600. I need to configure DHCP for e0/0 to obtain an IP via my service provider through the aDSL Modem. What command can I use to do this. It is my ...

I have a 3640 ,and have a trouble:I used the command "show interface s3/6" display "******** Last input never, output 1d02h, output hang 9w2d " and used the command "show contro s3/6" display "*** Transmitter hang count8 Residual indication count0 Bu...

I have TNPP (paging protocol) that sends alpha/numeric messgaes from a remote Paging terminal thru a 2509 and out the WAN interface. There are dedicated ports (from the terminal to the router) for customer messages, stat info, and alarm messages all ...

Does the Catalyst 4006 with Sup III support ISL trunking on a 24-port 100FX module?I need to connect to an older 5500 which supports only ISL.Can I upgrade the Catalyst 3550-24-FX-SMI to EMI?Does it then support ISL on the 100FX ports?

Hey all,We have a few 4908G-L3's throughout our organization. We have having a few performance problems and have come up with a specific question for you.Does the 4908G-L3 support __layer 3 switching__ of all IPX encapsulations?? or just Ethernet II...

I try to configure routing and bridging at the same time from interface fa0/0 to interface pos0/0. Is that possible in general?

Here is my scenario. I have the Business 500 package on the telephone line in the office. I do not have an ADSL modem, but I do have a 827 router and 5 static ip addresses. I want to use the 827 router as the ADSL modem and plug the 827 into the PIX....

Hi, We have a central switch (CAt4k6) with a Flat network .The workstations ping each other at <10ms but the NT Login takes place fter 2 attempts. What can be possible issues ?Regds/-Kaustav

Hi,can anyone explain to me how to set the managment vlan different than vlan1 ? ( I have a Catalyst 2924)Thank you very much, hopefully I´ll get it now !!!!! ;-)

Why do vlans bounce, just wondering if there is a technical explanation

Hi, my LAN is full of broadcasts which only slows down the performance of the LAN. I want to stop the incoming broadcasts on a C3524XL Gigabit port. Is there a way to do this with some access list or somehow else? Thank you!Vlado

Hello, Does anyone know the optimal transfer rate for NT servers with gigabit ethernet card on cat6509 switch?

we are facing in following problems :1. Logged in users is not showing any user list2. TACACS+ Accounting is not workingWe have installed TACACS+ (ACS version 3.0) Installed on NT 4.00 (Build 1381) Service pack 6 (128 bit high encryption)Internet Exp...