we are facing increasing number of connections to ourweb server and we want to know the capacity of a cisco switch ie how many concurrent connections itcan handle. Say, we have a cisco2926 switch.Any idea?Many thanks, Ta.
MPPC compression is not activiating when my Microsoft clients connect to my 3640 server.I have "enable compression" set under my PPP settings on my client.I have configured "encapsulation ppp" and "compress mppc" on my GroupAsync interface, but when ...
Does the singlemode fiber work for distances less than 500 mts using 1000BaseLX/LH GBICS...?....I am not sure if I can only use this kind of fiber for distances greater than 550 mts....
I know that I can use an access list to control access for telnet. Can you apply this to certain interfaces or is this for every interface on the router.
Hi all,We have a 3640 router whit (C3640-I-M), Version 12.2(2)T version. When we do a X25 call to some destinations who answer whit a different "called address" our router clear the call whit this message. Here are the debug lines: 8w3d: From (8): ...
Hi,I am trying to use a PC Dos based sniffer server from Network General(Network Associates)in my network.I'm new to this product..the issue is that when i boot up the server it allows me to configure the interfaces but after that it doesn't go to t...
c7200 hangs on boot and when I tried from rmon, got this message when trying to boot from rmon..*** Bus Error (Load) Exception ***Access address = 0x80012981PC = 0xbfc2091c, Cause = 0x1c, Status Reg = 0x3040d003monitor: command "boot" aborted due to ...
We currently have a single 1.5mb connection to the frame cloud and management has decided to add another in hopes of 'bonding' the connection to the cloud to 3mb. I don't think bonding in that sense is possible from our 3640. What are some options?
Please help me!I have looked over & over that the formula to configure CAR & it still makes no sense.Can someone please explain this too me?normal burst = configured rate * (1 byte)/(8 bits) * 1.5 secondsextended burst = 2 * normal burstIs the config...
We have a requirement of routing few hosts from only one EBGP link, by this we want to achieve that both inbound and outbound traffic from selected hosts will be forwarded only from the desired link and not from the other, and if the desired link is ...
I have a Cisco 2611 router which I use to connect to the internet but at the same time to some remote sites. I have a firewall between this router and my internal Cisco 2610 router which connects my LAN and other remote sites. My company says it can ...
