Other Network Architecture Subjects

I work for a small Building Society which has a head office and four branch offices (all within a 5km radius). We currently have 64kb kilostream circuit connections between the head office and each of the branch offices (with ISDN lines to provide re...

We have a 4908 where we have two subnets on the first physical port, 10.5.1.0 and 10.5.1.11, and the IP-helper points to the DHCP-server. If a computer on this first port broadcasts for an IP it will get one in the 1.5.1.0 span, but how could we conf...

Currently our root bridge is an access-layer switch because all switches are using the default priority and so the one with the lowest MAC address got elected.So I'm going to set the root bridge to be our core 6509. Once I make the change, will it ...

Old catalyst 2924XL support trunk ISL o 802.1Q,now catalyst 2950 replay 2924XL, but supportonly trunk 802.1Q, Why ?

Hi I am having problem with the vlan, defined a switch port as part of a new vlan. To which I have connected a Cisco Fasthub, I can not logg on to my local network.If i plugg the fasthub to another port not part of any vlan, i can connect to the loca...

I have a Cisco 2620 router (connected to a T1). I want to be able to limit the bandwidth useage based on an IP address of a user inside my network. I researched CAR (committed access rate) but found out that it only works with the 7xxx series. Any su...

I have a Cisco 806 broadband router and would like to upload the IOS firewall feature set (c806.bin). It is supposed to be done per Configmaker, but even the latest version does not support this router. Is there another way to do this?

I had modified country setting of sa.properties file,COUNTRY=ITA, and then restarted SA.Syslog reports show me always GMT +1, why?

In a multihoming to a single provider scenario, can the router load balance on a per application (ftp, e-mail ...)basis. How can I configure the route for this situation?

how to configure IS-IS on 1720 Router

Hello,I am having problem configuring a cisco 2501 router (IOS 12.0(6)) with external cus/dsu. My connection to my ISP is a T1 line .The router didn't take any of the following command. (I have configured a cisco 2600 router with IOS 12.0)service-mo...

I have recently configured second serial interfaces on three MC3810's to try and achieve better throughput for the clients Video Conferencing. I initially configured ip policy routing to route the traffic that was destined for the VC bridge or gatewa...

I have an Cisco MC3810 router with 4 E&M analog interfaces ( Type 5 - 4 wire ) that are connected to an PBX and are configured for use in a VoFr connection.Is it possible to configure a connection like this ( VoFr) changing the 4 E&M analog interface...

I'm trying to configure my router (2621) for vlan routing.I'm following instructions from cisco press.create a subinterface "int f0/0.1"then "encap isl 1" for example but my router does not understand the encap commandmy ios software is 12.1(3r)t2can...

any one tested cw2k (routed wan) using win2kpro and service pack 2?