Other Network Architecture Subjects

I have a Cisco 881 router configure with 3 VLANs on three different fastethernet ports. Each vlan has a separate network address vlan2 = 192.168.10.0, vlan3 = 11.0, vlan4 = 12.0My goal is to keep the VLANs separate from each other.( Example as: vlan2...

I need to calculate bandwitdh to figure out what kind of connection i need. I know if i take ONE single computer with wireshark loaded then run the programs then stop the capture.....How long do i need to capture it for? 1 minute, or 10 minutes, or ?...

Hello,I'm diving into switching details and saw the following:# show controllers cpu-interfaceASIC    Rxbiterr   Rxunder    Fwdctfix   Txbuflos   Rxbufloc   Rxbufdrain-------------------------------------------------------------------------ASIC0     ...

Hi All,Can we terminate an internet link with ethernet handoff on a firewall.If yes what are the pros and cons of it.how the routing will be done in this case.please assit with above queries.thanks

I've seen this happen on 2 different 'pairs' of 2950s, so it's time to investigate. The scenareo:simple trunk (no vlan definitions) between 2 2950s. 1 switch looses power, when power is restored, the switch that didn't lose power doesn't pass any tra...

I was doing some configuration reviews today, removing some lines that needed to be removed and came across an ACL I have never seen before.  I sure wish I could copy and paste into this thread!ip access-list extended cpp-managementclass-map match-al...

In my network I have to implement an high availibilty HA for the microsoft print services. I use the ACE 4710 in a new context with an unique vlan 103 hosting the ACE and both the microsoft printservers. I absolutely want to avoid the cluster SLB of ...

Can the ISG (Intelligent Services Gateway) redirect UDP traffic?On the documentation, I can't find where to specify protocol:redirect to{group server-group-name | ip ip-address [port port-number]} [duration seconds] [frequency seconds]

We are considering installing our DHCP services on cisco switches but how do you configure the dynamic DNS updates, which need to be send to a windows server, for DHCP clients registering on the CISCO IOS DHCP server ?

Case:--------CE -  (1841 + 4 s hdsl Hwic) device ISP  -  DSLAM (Zyxel) Dslam and Hwic supports ITU-T 991.2 standards In cisco compatiblity data sheet, it is compatible only with DSLAM ALcatel, ECI, Lucent But Zyxel is not mentioned. Here are my queri...