Other Network Architecture Subjects

Guys,For some strange reason, one of our suppliers needs to install a device (Nortel Meridian media card) which cannot have an IP address configured on it.The supplier engineer swears blind that on other sites, he can connect to this device just by u...

Folks Have two Cat 65K's running 8.5.3. I'm seeing two new messages being logged but find no corresponding documentation on CCO. Any pointers for these? I'm fairly sure of one but want to verify! Thanksejc%SYS-3-PORT_OUT_DISCARD:%SYS-3-PORT_RX_BA...

Hi allIf I have 3 subinterfaces for my vlans and they are on the 10.1.1.1/16 10.2.1.1/16 and 10.3.1.1/16, what netowks would I advertise in eigrp, would I need to advertise these all individually ?thanks

Guys,Very quick one, does anyone have any stats on throughputs on a VLAN Interface on a 6500 MSFC2I just remember the old days where if you had an RSM, and it had a VLAN interface, the throughtput was 400Mbps (or sommat like that)Can a 6500 MSFC2 SV...

I need to work out how to add a single port to a VLAN on a switch that is using PVLANS.For example port 3/7 is in VLAN 600I want to add port 4/6 to VLAN 600 but am being told 'unable to add port to vlan use pvlan command'The only PVLAN is isolated, a...

The question is: how can a Cat6506-IOS send through CDP protocol any of its configured IP addresses instead of its SPV loopback address?The scenario is: a Cat6506 SPV2-MSFC2 with IOS version 12.2(17d)SXB10 connected through a WS-X6516A-GBIC interface...

Hi there , I am still new in networking .I am facing a bandwidth over utilised problem to a remote site . When I ping the eo interfaces at some time , they will be a lot of time out and , I tried pinging a server , it gave the same result . I have ch...

HiI have a 2960 switch. Our ISP provided me with a straight-through cable and said that I needed to use a cross-over, and set speed to 100 and duplex to full.Instead, I used Auto-MDIX, but then I have to set speed and duplex to Auto - the switch won'...

I am useing 2600 series router and trying to link it with a 2950 switch, 2950 switch is attached with a internet connection & layer 3 switches, 2600 series router is connecting with 2950 at the client permises, what will be the port configuration at ...

I did the command belowclear trunk 8/15 2-210,212-1005 on a cat6k as I wanted only vlan 211 to be on the trunk.When I do a show trunk, all I see is Port Vlans allowed on trunk-------- ------------------------ 8/15 1,1025-4094I do not see th...