Hi, How does a switch distinguish one Vlan from another if trunking is not involved ?For Example: Switch A is connected to Switch B via a X-over cable. I place two ports at either end of the X-over cable into VLAN 2. I place one PC on switch A in VL...
my company has a cisco 4009 switch. this switch recently reboot serveral times. because other switch use the same power supply, but these swiths did't reboot. can you told me what was wrong and how to slove this problemi put sh log result at here
Hi, I would like to know if possible to upgrade my cisco 2950 switch IOS from Standard to Enhanced Image, As I notice from some one that it comes standard box with no uograde capabilities. Is that means as hardware upgrade or IOS Image Upgrade? Ankur...
I am trying to add redundancy to our network. Currently, we have one ISP connected to one router(2811) wich is in turn, connected to our firewall. I am currently setting up a second ISP going to a second router(2811). I will be running BGP on the ...
is it normal I have 0 OutPkts and 195 OutProc? I don't think so.. what is the problem? anyone can help please?InPkts: 63, OutPkts: 0, InBytes: 1197, OutBytes: 0InPRoc: 63, OutPRoc: 195, Broadcasts: 0
Hi, I am Facing a problem about assigning specific interface on 6505 switch as a trunk port that could pass specific tagged vlans, I would like to know how could I configure this interface as layer 2 interface and assign trunk that allows specic tagg...
If I have two ways to the internet and one goes down, is the only way to send users out to the internet through a floating static route? Such that,ip route 0.0.0.0 0.0.0.0 10.10.10.1ip route 0.0.0.0 0.0.0.0 10.200.10.1 100, where the 100 allows the ...
Dear SirsI have Cisco Access point 350 with IOS 12.2 JA, I want to upgrade it to 12.8 IOS version. I have download the c350-k9w7-tar.123-7.JA3.tar file from cisco web site and copyed it to flash from TFTP so I thouth that I have to remove the old OS ...
In a big hierarchical network architecture (Core-Distribution-Access) is right to have ospf routing running on core switches? I mean... should I build an high speed L2 Core or should I connect the Core to the different distributions using small inter...
I have a 2955 switch that has been installed without completing the inital set-up. The switch is currently being used for a sensitive process that cannot be disrupted. My question is if I set the switch up via the console connection and assign an I...
Hi folks,We've just purchased two 6509's with redundant sup720's and two 6506's with sup32's, and I need to configure them to replace our aging Extreme switches.Two will be in the MDF on ground floor, and two in the IDF on second floor. All floors ha...
I would like to know if a 2950 switch supports a span session from a single source interface to two destination interfaces. Switch is running image version 12.1(22)EA1. Thanks Mark
I noticed today I had the following error message appearing in one of our 6500's. We're rebuilding with Sup720's anyway, but I would still like to know what my error messages mean. After unsuccesfully finding any information online I have come here...
