Other Network Architecture Subjects

I have some questions regarding the switches mentioned in the subj.First, I hope someone could tell me what is that thing with limited routed interfaces on 3550? Documentation says that this switch is optimized for 8 routed interface (SVI and physica...

Hi,I have a Catalyst 3550 which I am going to use for 7940 Phones and workstations. The workstations will all be connected via the switch on the back of the phone. I would like the phones in their own VLAN (Voice VLAN 20). I am assuming that the p...

Which one of the Catalyst 2950 series support SSH crypto and port mirroring? or which IOS image supports these two features that I`m able to load into 2950 switch?thanks

I would like to use this Hw platform with OSPF but all the releases I found refer to SUP III or SUP IV (12.2(20) and above).Is it possible ?Example :http://www.cisco.com/en/US/partner/products/hw/switches/ps4324/prod_bulletin0900aecd8015f3db.html

I'm going to interconnect 5 3750 in 5 different floor of my office to eachother.BW I need for each floor is 1GB. I want to connect them to my 4500 with SUP V .are they share 5Gb BW or not ?

Hi All,got 2 that display nothing via serial com port. Settings are different perhaps.? All Cisco switches/routers I've used so far use 9600 8N1. Cheers.coolboarderguy...

Hi All,after setting up routers with their hostnames and IPs, can you direct them to forward their details to a DNS, or, do you need to do this manually, for each device..? Sorry, still learning this area of networking. Cheers.coolboarderguy...

I am trying to ftp a new image to a 6513 because the image is to large to tftp. In the comand line string where do I put in the user name and password for my ftp server?

Hi, I wonder if some one could clarify if MST uses VLAN 1 for exchanging BPDU'S or does it uses that particular vlan that is configured under native VLAN for the interface. Thank you, Venkatesh

Hello,My company just purchased a 5505, with a sup2 MMF(WS-X5506)and four WS-X5224. With this hardware, the system boots fine. When I installed a sup3 NFFC (WS-X5530), remaining hardware same, it won't boot. Console shows:System Bootstrap, Version...

I am trying to have 3 group of 4 GigE ports on the 3560G as a etherchannel and connect to 4 dells. On gi0/7 - 10 the trunk config seems to work but I am not able to route between the switches. Here is the config ... Can anyone take a look tell me w...

Hi, How do I configure Cisco 837 router for cable connection?I'm connecting to SCV Cable Maxonline in singapore. Hope someone can help. Regards, Junhan

I have two building which the connectivity is the laser bit wireless network. Now I have also two DHCP servers at both side. I want building A will get the IP leasing at DHCP server(172.20.1.0) at building A. While building B should get also IP leasi...

Hi,I would like to allow some users full access to internal servers, but only provide them with 2 Mbps access to the Internet. As far as I understand I cannot use the deny statement when defining the access-list for the class-map and therefore I am a...