Other Security Subjects

My company is considering outsourcing our security services. Can someone who's done this before give me some feedback?

so, I have just installed VPN Client 4.0, and appears the error windows: The necessary VPN sub-system is not available.......What shall I do, or what shall I test at least? I have installed it for 3 times.I am using DSL with pppoE, the ICS is being d...

IDSMC is up to 4.0-2-S46 and the sensor is 3.0 and should be around 45. I applied the newest idsmc patch. When trying to add this sensor BACK to the mc after removing it, i get the following error:An error occurred while trying to save the signatur...

I am trying to upgrade a 4.0 Sensors signatures with CiscoWorks VMS. All of the 3.1 sensors upgrade with no problem. However, when I try to upgrade a 4.0 the ip audit log generates this error:"10.1.4.252: Error importing sensor version from the sen...

is it possible to do VOIP with VPN. I am planning to install 3002 hardware client at site and do VPN through internet backbone. I also want to connect VOIP phone to 3002 hardware client? I need to know if 3002 hardware client will support voip ? Than...

I installed SDM 1.0 on our 3620 router. When I go to access the SDM via either http or https the inital page comes up, but the pop up manager doesn't come up. I have it loaded into slot1 flash as we don't have enough room in default flash. I tried th...

Hi All,I have a primary and secondary switch set up with multiple vlans on each and trunking between them. I also have a primary local director bridging between two of the vlans on the primary switch with a failover local director doing the same on...

i upgrade os on the pix535 from 6.0.1 to 6.1.4, after reboot, why pix535 notice the message:Ignoring PCI card in slot:4; and the pix535 not to boot correctly,and notice :no enough the network interface.

I'm trying to telnet to an address inside my firewall and receive the following error message305005: No translation group found for tcp src htzlan:192.168.180.187/2117 dst management:192.168.182.33/23. Can anyone explain what might be happening?

Dear All ,I use IDS Sensor 4230 with version 3.1(3)S44 , and unix director version 2.2.3 S44 . The problem is that some of the events in the packetd on the director are displayed by their event numbers not by their name like the most . This is new an...

Hi,I've this CW2KVMS 1.0 server running few mths ago & noticed that the syslog file under the CSCOpx\log\ directory is keep on increasing its size. Besides, every time I launched the event viewer from the IDS Security Monitory, it says that the no. o...

We have a 10 sites with Pix 501 configure with EZVPN and they all terminate to Cisco 3030 concentrator. We have few users in one of this sites, and this is the only site that are constantly accessing Oracle databases which is siting in a network beh...

I am having this problem with Windows XP users who have Outlook 2000 in Exchange mode. Most users (including me) can connect fine over dial-up or broadband with no problems. A few of my users cannot communicate at all with my Exchange installation ov...

I am trying to allow access from one computer in the dmz to our internal network. This is a temporary setup used for testing. Can anyone point me towards documents on how to do this? I am not mapping to a "legal" address on the Inside. I just wan...