Other Security Subjects

In the middle of configuring a fresh pix 515e with cli 7.1(2) and asdm 5.1(2). ASDM loaded up just fine saved a couple of changes and reloaded a couple of times. Had 3 interfaces enabled and and some static routes from outside to dmz1 with access-lis...

issue # 1: Cannot upgrade PIX515UR from 6.3 to 7.0 in monitor modeMonitor mode required because there's no enough memory to do it in normal mode.I am experiencing the same problems as seen on another post but I can't getting working for me:http://for...

Hi, My friend deleted the IOS image on the PIX515E accidentally, after that he reboot the PIX.Now, there is no IOS image in the PIX. How to fix it? I know how to fix it for router and switch. But I never had done this for PIX before.Anyone has the go...

I am having a problem with Dynamic Multipoint VPN on a group of 2800 series routers.The tunnels between the spokes and hub work fine, but the dynamic tunnels between the spokes do not come up with normal traffic. I can cause the tunnels to be created...

We have new 7609 with Firewall service Module.. But for some reason, the FWSM does not take any commands in the 'config' mode.. I can not enter the nameif command or any other commands.. What could be wrong?.. Thanks in advance..

Hi - I'm using the pdm for the FWSM. I'm trying to NAT a server from the production VLAN interface to the outside interface with a RIPE address so that we can send smtp to it from designated internet hosts. This server is in the 10.x.x.0 /23 network ...

I have a PIX 515E behind my router (2600). I am trying to setup the PIX to forward SMTP to one server (192.168.1.4)and HTTPS to another server (192.168.1.11) using the same external IP address (192.168.100.10) when I enter the information below on th...

From the manual:# access-list NET1 permit ip 10.1.2.0 255.255.255.224 209.165.201.0 255.255.255.224# static (inside,outside) 209.165.202.129 access-list NET1i receive: "global address overlaps with mask"Using different ip or mask do not change the er...

Hi ;i used webvpn for VPN connectionsit Just opens Citrix web interfaceBUT ... when i try to open any application it gives me an error.stating that Citrix application error despite that citrix is working properly and no problems.

Hello,Is possible to have one context in routed mode and another context in transparent mode?This is what I need in my scenario.Any help will be welcome.Thank you.

This bug has now been junked and I don't see it as a resolved caveat in the 7.1(2) release notes.Anyone know what's going on with it?

Hi AllNeed some guide or explaination on the different between these two.We are configuring a site to site VPN Between a cisco ASA and a watchguard firewall. The issue is the Watchguard firewall using only 3DES-CBC or DES-CBC, Does the cisco ASA or p...

Hi,I am deploying a Cisco 3845 with 6 T1 interfaces, 4 for a private MPLS network and 2 for Internet access using Multilink PPP. All Internet traffic will hosted at this facility. I am a little confused on how to setup the firewall and NAT.Thanks

I've just had a new PIX delivered with V7.0(4) installed and I've been trying to upgrade the 3DES licence.have gone to http://www.cisco.com/go/license filled out my details, added the serial number from the PIX, been emailed the new activation key......