Hi,What is the limit on the number of OTV-connected sites on ASR 1K? I saw this doc for NX-OS: http://www.cisco.com/en/US/docs/switches/datacenter/sw/verified_scalability/b_Cisco_Nexus_7000_Series_NX-OS_Verified_Scalability_Guide.html#reference_18192...
Forum Posts
I need my CISCO certificates or passing score report of my previous passed certifications- 642-747- written on Nov 4, 2013 and 300-07. The score reports are not available under https://wsr.pearsonvue.com/testtaker/registration/ViewScoreReports. I hav...
So, I have an IWAN deployment (DMVPN) with 47 sites in the deployment. Most sites have 1 WAN connection and 1 Internet connection that are used for Tunnel 10 and Tunnel 11 respectively. The configuration is pushed out from APIC-EM, so every device is...
Hello Community I configured a DMVPN hub and spoke tunnel, and my voice dhcp server is in my hub I will now configured so that the phone on my spoke will look for ip address and configuration on my router hub ,What to do please?
Hi folks. I'm currently CCENT and studying for CCNA. I have decided to build my own home lab and use my existing SKY VDSL connection with a cisco 1117 router and an ASA (yet to be decided / purchased). I'm a little hazy shall we say as to the best w...
Why does ospf not store wildcard 172.16.30.4 0.0.0.7 area 0 instead it stores it as 172.16.30.0 0.0.0.7 area 0 in the running config
Hi,i'm bulding a POC and need some advise. Topology: -------------------- - - - Firewall - int E0/0 (192.168.2.1/24) - ...
Hello everybody... My link on nexus 7710 back to back connectivity is not coming up....it says notconnected since modudle is connected...any suggestion. Regards,
Hi guys, would like to ask if you encountered the same crash log below on your 5508 WLC. --------------------------------------------------------Beginning of Crash File: mwar_dump2.crash--------------------------------------------------------0x1000...
(router0 is off to the left, "off switch1" ) PC2 down at the bottom is on network 192.168.0.0 (connected to dg, 192.168.0.1 (router0) PC4 is connected to router2 ( default gateway, being global address 192.168.3.1 ) My question is why can't I ping...
Tracer I'm using Tracer and I'm doing a VLANS, sub interface but I cannot ping the computers, I can ping the computer to router and to switch but not btw computer. I need to know what I'm doing wrong please help. LEG A: VLAN 10 and 20 are develo...
Hi Experts,I need your help to understand the logic behind the NTP access restriction. I learned that, NTP access-list as follows:1. peer - Allows time requests and NTP control queries and allows the switch to synchronize itself to a device whose add...
Hello, We are running out of IP Addresses in our DHCP scope, so I have been tasked with sorting this out. One possible solution we are considering is to setup a second scope and use Superscoping. Our main IP range is 192.168.0.0/24 and we would lik...
Good Morning Team, Facing issue in Cisco ISR4321 frequent reloading & hang issue, please support for debugging issue. Regards, Niraj
We have a new installed DSL circuit. The ISP provided us with static IP info. Gateway IP Usable IP address Subnet Mask I have setup a router interface from the modem to provide internet. The interface IP address is configured as the usable IP and...
