Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Hi guys,I'm thinking to implement new model router for my infraestructure and I would like to kown what would be the best option.Currently I have two MPLS provider and I will need to garatee the communication to Central Data Center. and deploy diferr...

JRGC by Level 1
  • 3327 Views
  • 2 replies
  • 2 Helpful votes

Hello Everyone   Quick intro - I am currently studying for the CCENT and only have ACL's, NAT and IPv6 to cover. I have set up a home lab with 3 routers (2x 1841 and a 2621) and 3 switches ( 3550, 35700 and 3560). So far I have managed to solve most ...

IMG_20171217_161515.jpg
Tom_R_R by Level 1
  • 578 Views
  • 3 replies
  • 0 Helpful votes

i have dsl line with rj11 if i modify this to rj 45 it will work on cisco 1941 with pppoe configuration router or not   

akaa by Level 1
  • 280 Views
  • 1 replies
  • 0 Helpful votes

1)Two hosts are attached to a switch with the default configuration. Which statement about the configuration is true?  A. IP routing must be enabled to allow the two hosts to communicate.  B. The two hosts are in the same broadcast domain.  C. The sw...

Hi Community Team' I hope you are doing well. I am trying to configure PPPoE on Catalyst 3750G-24TS for users to authenticate with remote radius but I couldn't find the some of commands. Currently My switch SDM template is "Desktop routing". Please s...

We have 13 sites and 1 data center (host site).  Our topology will be point-to-multi-point.  We will be using ASR 1001-X and ISR 4331 routers for the EVCs.  Looking for configuration samples I can use as reference in configuring the bridge-domain, se...

I have two  Ethernet hand-off Internet circuits from two different ISP at two different locations.     There are three locations connected internally, and  the bridge VLANs across all three locations.   The two ASR ISP routers (running IP services) ...

abbasali5 by Level 1
  • 1411 Views
  • 1 replies
  • 0 Helpful votes

  Dear Team,   I am running HSRP for my LAN.whenever my R4 is going down R5 came to active but if R4 came up again the fall back is not happening up to my R5 is going down.   R4 :   R4#sh run int fa0/0Building configuration... Current configuration :...

sankarmay by Level 1
  • 995 Views
  • 5 replies
  • 0 Helpful votes
Unanswered Topics
Review Cisco Networking for a $25 gift card