Routing

I have configured AAA on Cisco 2960 & also configured AAA client in Acs 5.2. But i am not able to login via Tacacs & i have to login via local. Here is config on Switch: aaa new-model!!aaa authentication login default group tacacs+ localaaa authentic...

Hi Guys, Good Day! Need help. I have 2 router which I managed and I want to connect it to an ISP router via BGP. Is this a possible setup? Just want to have redundancy link. R1 --- connected to ISP1 R2 --- connected to ISP1 Thanks

Dear All help need. I have two links coming from MPLS could as primary and backup Attached the scenario. I would like to have Link redundancy for our MPLS network. Kindly tell me what protocol service I could use to achieve this. HSRP or GLBP Detail...

Hi, i would like to Inquire about frame relay protocol My inquiry is why we need sub-interface in a frame relay in a  point to point connection .

We have  a Cisco 6509 s72033_rp-ADVENTERPRISEK9-M), Version 15.1(2)SY4a and we receive full internet routing table from tier 2 provider, Problem is that whenever the peer goes down and when it comes back up it takes  forever to populate full internet...

Hi Please have a look at the image What is the command to check the ingress Real time Traffic on Parallel Links of OSPF? I want to see real time incoming traffic on R2's both the ingress interfaces. marked as green.  I am sending Ping or any other ...

Hi , Iam facing issue  with EIGRP not load balancing . Just to give  you all a  quick  background .  The branch had two ASR  routers. One of the ASR router( router 1) is  connected to  a Hub router (  let me call  it Hub 1) and another ASR router(ro...

Dear Team, i have cisco 1900 router in my office i have configured dns and dhcp as mention below .my dhcp client is getting ip in 10.10.11.0 range but getting dns as 8.8.8.8 4.2..2.2 because of that i an not getting resolved internal network host na...

Hi Guys, Good day! I would like to ask if this is possible. I have 2 ASRs, 2 N5Ks, and 2 N2Ks, the requirement is that in my 2 ASRs I need to configure multiple VRFs and in the N5K I need to configure VLANs. My question is that, how does the N5Ks' kn...

Configuring a cisco switch and a router. How to operate a server on a network

Hi, i have a quite large network working with RIP as a general routing protocol. All those routers are the backbone. The ISP provides a backup backbone running BGP but the RIP backbone is slected as principal backbone for all the traffic. In one buil...

Hi,   I need to config the new router but I need some details of your router.   The topology is the next.                                  ISP 1 >  Cisco 800 -> Cisco 881-4G (with SIM, ISP2) -> LAN   I know that this topology is a little rare but I m...