Routing

Hi All, can anyone suggest why I only get the first routing update from RIP, I'm just advertising the default route to a remote site. The remote site receives the RIP route but it then times out as it does not receive any more updates. The timers are...

Hey guys i have catalyst 2960 and having the following problem on interface fa0/5 I'm getting errDisable state  I tried opening the port normally using no shutdown i get connected and then 5-10 seconds later i get errDisable i have tried to set the s...

Hi! I have some TCes in status "DISABLED due to application overlap" so they are not controlling by PfR.  All TCes learned by target-discovery from another location. Policy configured depend on QOS field. Prefixes don't depends on site or configured ...

As shown in attached file pc3 & pc6 are in vlan 10 pc7 & pc5 are in vlan 1 how all pc3,6,7,&10 will communiate with all other pcs that are in other n/ws switch int f0/1 already configured as trunk port ... then how configure router port as trunk......

Hello,I bougth cisco hwic-3g-gps-cdma module on the ebay for home lab on the cisco router 2851.But when inserted hwic module into router 2851 the command show diag print follow: WIC Slot 0: 3G WWAN EHWIC-DuoBand EVDO Rev A/Rel 0/1xRTT and GPS WIC mod...

On a C3560E switch I have a VLAN which contains a number of devices, DHCP/DNS server, etc. It is configured as so: interface Vlan60 ip address 10.0.1.1 255.255.255.0 There is a cable modem plugged into the 3560, with its port configured as so: int...

Hi, I have setup DMVPN as backup link to primary MPLS. I have mutual redistribution between ospf and bgp for the primary MPLS link. I am running EIGRP on the DMVPN and redistributing between ospf and EIGRP. My topology is two HQ sites and two remote ...

Using Cisco RV082 router I established a site-to-site connection to Amazon Web services VPN service.I'm using a static IP address assigned to WAN1 interface on the RV082 router.I confirmed with AWS that all is correctly configured on their side so I'...

Hello Everyone!! I have a P2P link between 2 Offices (layer2 link) 3560x------3560x I need to limit the bandwidth (we pay for 10Mbps), tried the commando below but users are still getting higher speeds SW-CORE-01#sh run int g0/20Building configurat...

Hi! Where speed limit on ISR 4000 is applied? Is it sum of all traffic on all interfaces leaving the ISR? Do switch interfaces count? Do internal interfaces count? do inter-VRF routing count? What do these 50 mbit/s mean? Thanks!

Based on the documentation, we are only allowed to have one hub Master Controller per domain ID?  Is there a possibility to have active/active Hub MC's?  If there are 2 DC's and the MC at the HQ fails what options do we have besides the Branch MC det...

Please can you help me to configure port forwarding in the router cisco 887vaI want to access my private ip from out side through my public ip using port 80i do all NAT commands no thing changedplease help menote : i have 2 public ip's I attached th...

Hi, I wondered if anyone has any experience in bundling 2 fibre broadband links together, we need extra capacity for a wireless network that is used for guest wifi and testing purposes. The single circuit currenly has a b/w of around 50Mb, but I was...