Routing

Hi I have a router with two ISP's one interface is 100Mbps(ISP1) and the other is 1Mbps(ISP2) Then i have configured BGP across them without tunning anything, will it take ISP1 as the best route since it is having the higher bw??? Or in what conditio...

Hello All, I have 2 Internet connections coming into a 6800  2 different ISPs.  50Mbps and 100Mbps.  I would like to use both of them at the same time.  Can someone tell me what my options are and the pros/cons of each?  I know there is load sharin...

Hi Guys, this will hopefully be a quick and easy question for you guys to solve. I have a router that I have to put a very basic configuration on just so out ISP can remotely log into it and begin their more detail configuration. I have configured i...

dear cisco, i need some some help to include my cisco router into my network? see the attachment below

hello I have configured a policy of 2Mb both outbound and inbound  on my ethernet interafece. And I was trying to ping the point to point with a packet size of 1024. Which gives me around 5-6 drops out of 1000 packets. But I dont have any drops when...

I have the following config: l2tp-class networkstV3class authentication password L2TPv3 pseudowire-class NETWORKPWencapsulation l2tpv3protocol l2tpv3 networkstV3classip local interface GigabitEthernet8 interface fa 0description LAN Facingno ip addres...

Hello Experts, I am unable to forward traffic from port 80 to an inside device on the native VLAN. (192.168.10.5) I believe the issue is somewhere with an access list. Please advise. I have attached the router configuration. Thank you for your help...

I'm looking to configure a NAT router   server-------NAT Rt-------client   I need the client to think it talking to the NATRt cleint side.   And I need the server to to think the access requests are coming from the NATRt.   Effectivily each are unawa...

Problem description:We have point to point link running BGP , we implemented BFD for fast convergenceand EEM to shutdown the BGP neighbor-ship once the BFD is triggered.The issue is with the EEM script we can see only the action number 5 after the BF...

Hi, I have a 3660 router which is on 12.3 pre the IP SLA command. I was wondering if anyone could remember if its possible to do a IP SLA style redundancy on internet connections without using the IP SLA commands ? Or was it purly reliant on routing...

Hi All, i currently have a 1921 router and will have 3 different vlans. When the devices are connected to the 2960SW i cannot route any data? I have setup the VLAN id's on the 2960SW '5,6,7' but cannot even ping the router from the switch. What am i...

Hi guys,Need your help on this. Can I know, what is the maximum flash memory capacity can I upgrade on Cisco 1750 & 1751. I need to use minimum 32M of flash memory to upgrade my routers to IOS version 12.3 and up.And also can I upgrade the memory to ...

Hi, I am setting up VPC between two Nexus 5624Qs. However it is not coming up. There is mismatch between the vpc parameters of local and peer. below is the output of sh vpc consistency-parameters global     Legend:        Type 1 : vPC will be suspend...