Hi everyone! As far as I know, the Multiprotocol BGP can support multiple address-family, while the standard BGP can only support ipv4 address. However, I am not sure how to determine if a BGP is standard that can only support ipv4 or MP-BGP that can...
I'm experiencing routing challenges with my website hosted on a Cisco networking infrastructure, and I'm seeking guidance to troubleshoot the issue.I have a website hosted on a server connected to a Cisco networking setup. Recently, users have report...
As we reviewed our router settings, we noticed that the top talker's feature was not enabled. To activate it, is there any IOS update required to configure the Top Talkers functionality in our router?
Hey, i am student. And for a school project we have to make a network for a company. I don't really now how to start this project. Case study The newly purchased building consists of a reception department and an administration department + managemen...
How is it possible that the default gateway on 24.205.84.1 works with an address 24.205.86.91 /30 on the wan of my home router?
Hello all, unfortunately I'm stuck and I don't know what to do. I configured the switches: created VLAN 10,20trunk with vlan trunk allowed vlan 1,10,20 between the firstfloor and secondfloor switchestrunk from secondfloor switch to routeradded client...
Hi all,I've been given a PT file (attached) to troubleshoot for a uni module. I'm slowly getting to grips with routing, but this one has confused me.I've worked my way through the IPv4 and IPv6 configurations and made a list of what I think is wrong....
HI everybody. I doing so small study project with routing RIP v1 for study.All network work in same net 200.100.100.0 but i got couple router between department. Mayby somebody get some advice for me. i attache project from packet tracer
hello, do you guys know why does my pc12 can't ping to server and, please check my network configuration i am not really confidence from what i've configured it seems like i miss something important, thank you
Good afternoon all.I have about 50 sites, all of them have extended ACLs, with the networks source IP (different at each site) and some destination hosts( that are the same at each site) , that can change every few years as we upgrade our systems.The...
Hi all,we just installed ncs57C3 mod in our datacenter as core bgp router and it reboots itself alnost each 3 hours. Here is the log: 0/RP0/ADMIN0:Jul 5 07:33:48.000 UTC: shelf_mgr[2131]: %INFRA-SHELF_MGR-6-HW_EVENT : Rcvd HW event HW_EVENT_OK, even...
I just purchased a cisco 1921 off e-bay and it appears the current config has an att config that I can not reset. I have tried booting into ROMmon to no success. I have tried taking out the flash memory and booting a few times to try to get it to boo...
Could anyone please assiste me here?I have a Cisco 9001-LC that is stuck at rommon.I'm trying to turboboot using asr9k-mini-px.vm-6.4.In Rommon, I am not seeing any Disk available and I am unable to see the usb when it's inserted.devDevices in device...
Hello everyone,I was setting up a simple lab and came across what, in my opinion, is an anomalous behavior. Below is the photo of the topology. So, I have 2 routers, R1 and R3, with their configuration provided below. I tried to create a BGP session...
Hi Team,I have an issue with this topology, the main switch can ping to the main router on the vlan subinterfaces (192.168.10.2 and 192.168.20.2) the internal PCs can ping these subinterfaces as well. Now the issue is, the main router can ping to 8.8...
