Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

 
Labels

Forum Posts

Hi, When we configure NET for every router running IS-IS, NET consists of (Area ID, Sys ID and NSel) Question is when i do # show clns is-neighborsor#show isis neighbors, I expect to see the System ID which i used on all routers' NET.For eg if my NET...

chinart13 by Beginner
  • 3030 Views
  • 3 replies
  • 0 Helpful votes

Hi,I would like to setup DMZ in my network to access 5 servers from internet. We have total 6 public IP's from service provider. We have firewall ASA 5510 with 4 ports. 1 is used for  outisde interface with public IP, another 2 are set in redundant i...

mshupatel by Beginner
  • 4550 Views
  • 11 replies
  • 0 Helpful votes

Is it possible to have a user enter in a user name and password to access the internet on a cisco 800 series router? Say they open IE and type www.google.com and before they get access to the web they get redirected to a plash page for logon credenti...

Hello,i need an expert !we are deploying ToIP over our 40 sites.Dhcp is in our main site. all sites are connected over the wan. Look attachment , and check @mac source and destination its juste amazing... @mac source does not match with the @mac dest...

Hello Guys I have a scenario where I would like to have your insights. 1. Client having Main site and DR site connected to same ISP with public IP line.2. The client has acquired a public IP block (/24) and would like to use same on both main and DR ...

I installed a E1200 router in my in-law's home and the connection keeps dropping. When working there will several devices successfully connected some via wireless (some phones, ipad, laptops, Roku) and 1 desktop hardwired.Usually once or twice a day ...

Hi guys,I've a problem with a router 2811:Upgrade ROMMON initialized program load complete, entry point: 0x8000f000, size: 0xcb80 program load complete, entry point: 0x8000f000, size: 0xcb80 program load complete, entry point: 0x8000f000, size: 0xe36...

Hi I am changing IOS of Cisco ASR 1001  from asr1001-universalk9.03.07.02.S.152-4.S2.binto asr1000rp1-adventerprisek9.03.04.02.S.151-3.S2.bin but everty time it boot up with old IOS universalk9. Is it becaused of Licence issue.Router#sh bootvarBOOT v...

raut.pawan by Beginner
  • 2505 Views
  • 2 replies
  • 0 Helpful votes

Hi all, We use an infoblox device as our DHCP server, so in principle all MAC addresses are known on this server. If you want to do authentication based on MAC address, can you speak -one way or the other- with the Infoblox device?

We have 2 4500x switches with Ent Services licences.  The plan is to replace the current core routers with a L3 switched core using the 4500x with VSS.  The core will connect 3 building data closets, a local data center and 18 remote WAN sites.  Engi...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Unanswered Topics