Routing

Hi Guys,I have posting the debug commands. Not sure where i am going wrong. Tried several combinations but no luckTrying to establish site to site vpn. My side is cisco ASA 5520 and other side is RV180Date/Time IP Address Host/Domain Priority Facilit...

i have an alcatel oxe PBX(CPU TFTP IP@ = 172.17.0.4 )with internal DHCP server (range 172.17.0.10 _ 172.17.0.200) connected to L3 CISCO switch.the customer has two different subnet network for two branch ((linked to the L3 CISCO switch)) :first subne...

I recently received an 1811  router. It appears to have some corruption. On bootup I get the following:System Bootstrap, Version 12.3(8r)YH13, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 2008 by cisco System...

Hi,I have another problem - after upgrade ios wirelles connection not work. After reload i have :Configuration of subinterfaces and main interfacewithin the same bridge group is not permittedSTP: Unable to get the port parameters.Please configure the...

i have vlan separated by a switch my pc's can communicate on their own lans but not across the wan can anyone help me pleaserouter 1Router#show runBuilding configuration...Current configuration : 1004 bytes!version 12.4no service timestamps log datet...

Are LAMP services running on ARM compute architectures not the direction of telecomputing?  Looks that way to me.  Anyone have more detail around the ISR4000's processor specs/OEM info?RISC vs CISCHistorically, Cisco networking devices were powered b...

Hi all i have a doubt regarding area 0 which is known to be backbone area and all other areas attached to backbone area by an ABR . Why can we make any other areas as backbone say area 1 is made as backbone and all other areas connected to this area ...

Hi, My router is showing all the routes but cant some of the vlans and routes until and unless i give following command. clear ip eigrp neighbors After giving this command it manually clears neighbor table and then makes new adjacency. What can be th...

I have problem TCAM on my Router, Hardware CEF entry usage is at 95% capacity for IPv4 unicast protocol,i use both IPv4 and IPv6, so i cannot customize the use of Route.what memory should i upgrade if i want to increase TCAM ? MSFC ? should i upgrade...

Hi everyone, I've got a problem of interface on Cisco WS-C3550-24 . In log can see a  frequent changes of state of the interface. The line protocol is changed state to down and to up and to down and so on here's loggJan  2 14:03:52.650 TJK: %LINEPROT...

about power a ie-3000-8tc, I don't understand the difference between an PWR-IE3000-AC and (PWR-IE65W-PC-AC= OR PWR-IE65W-PC-DC=).which one should  I use? thanks PD. 22-dic-2014. after 15 days, looks like nobody knows the answer to this question.

Hi Guys,Im learning 2 default routes from upstream providers via eBGP (plus full tables) on one PE, and I want to leak the default route (Plus other prefixes, based on community tags) to a VRF.....just after some guidance on how best to achieve this?...