Routing

 Hello Scneario: My network is upgrading. I am implementing (2) WAN links at seperate locations using different ISP's. See DiagramQuestion_1:                  What is best practice for Multihoming using BGP?                  Is that the best approach...

All, I am working on setting up a 2811 router to act as a PPPoE client for a newly installed DSL connection.  I am running debug on the router and I see the PADISNT going out.  I see the PADO coming back to the router.  I then see the PADR leaving fr...

Hi,Can experts here guide on two queries below..01: I know only speed mismatch causes the connection lose.. but if two ends are configured at auto/auto and I just set duplex at one end as "full" (speed remains auto/auto).. will this cause connection ...

So I have a remote office connected via an MPLS.  I am adding a broadband connection to this site as well and want all port 80 and 443 traffic routed out the Broabband connection.  The mpls is serial0/0/0(55.55.55.55/30) and the broadband is connecte...

To use a DS-3 card on 29xx routers, we have two options: Option 1 (old NM module): Use "NM-1T3/E3" with "SM-NM-ADPTR" adapter.Option 2: (new SM module): Use "SM-X-1T3/E3" However, these two options seem to have different compatibility on 2921/2911 ro...

Hi allI've read in the 'IP Multicast Best Practices for Enterprise Customers' whitepaper that Assert can cause issues which states the following:"Assert issuesThe PIM Assert mechanism prevents duplicate traffic from flowing into a multi-access networ...

How can overwrite the command???  redistribute static route-map unu  ---> in redistribute static  without   no redistribute static route-map unuredistribute static

I have 2 switches, one is a Cisco 3750 and the other is a Cisco 2950.I can ping the interface from each switch on each PC, and vice versa, but I cannot ping across the trunk port from PC to the other VLAN.  I am definetly a noob at this so any one th...

I have 2 switches, one is a Cisco 3750 and the other is a Cisco 2950.I can ping the interface from each switch on each PC, and vice versa, but I cannot ping across the trunk port from PC to the other VLAN.  I am definetly a noob at this so any one th...

Hello,am set the traffic shaping as below but i don't know why the offer rate t can exceed ?sh policy-map interface f0/1 outputFastEthernet0/1  Service-policy output: pm_top    Class-map: cm_icmp (match-all)      18646 packets, 23677532 bytes      30...

HiI'm planning on redesigning our WAN network. Currently hub and spoke with a mixture of 10mbs, 20mbs, 100mbs and 1G with layer 1 and layer 2 links. Some are true layer1 with just piece of fiber between the sites others peering with the carrier is at...

Hello All, I have bonded T1s together before on a router to get 3Mbps through put instead of 1.5.  Can I do the same with two 50Mbps connections from a cable Internet provider?  I think the T1s had to be provisioned specifically on the ISP side as we...