Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello,We have a Cisco 1841 DSL router in a remote office set up as a VPN back to out HQ.  It has become unrealable over the last few days and te ISP say the line is fine so it must be our router.  It has been running for years without issues.I'm wond...

Hello,I have a little trouble, i want to deny all the trafic for a certain mac address, on my cisco router 2000 series.seems to some users change his dhcp ip for a static one and make some colitions on my devices, i have not permition to block the ac...

Dea Friends,I have two offices ,one is branch office and other is head office.Two MPLS link is connected with each other,One link is always back up when other link is goes down .In running time only one link is working other  as a standby but i want ...

           Hi ,i have cisco 3560x 24 port switch  series switch i have installed C3KX-NM-10G module on same switch Problem : when i connect SFP on G1,G3,G4/te2 ports are not active only G2/te1 is active but when i connect same module and SFP on other...

I have failover configured, tested, and verified using IP SLA, policy-based routing, and NAT failover as outlined in this guide:http://docwiki.cisco.com/wiki/NAT_failover_with_DUAL_ISP_on_a_router_Configuration_ExampleThe problem is it takes about 60...

ualbdp2c1 by Level 4
  • 4513 Views
  • 4 replies
  • 0 Helpful votes

Hello All,I am following Jeremy Cioras lab on BGP for the CCNP Route. BGP remians IDLE.What am I missing?I have two new Just Started 7200 routers, connected to se1/0 on both with a serial connection.R1: 10.1.1.1 255.255.0.0 AS 6500R2: 10.2.1.1 255.25...

I have catalyst 2960 and router 1841 with Vlan configuredRouter is DHCP server for eache VLANI also have ISE(192.168.101.60) on central siteBut user cannot get IP addressWhen I connecte on switch port interface GigabitEthernet0/1, I get an IP address...

nicanor00 by Level 1
  • 609 Views
  • 3 replies
  • 0 Helpful votes

helo................can anyone help me,i can use this command on my Aironet 1240AG configure terminal  error like this :ap#configure terminal    ^% Invalid input detected at '^' marker.ap#conf t    ^% Invalid input detected at '^' marker.ap#plzz i ne...

HiI am having a problem with connecting my two Cisco switches one is a Cisco 3750X to a Cisco 2960S I have new SFP GLC-LH-SMD conneted to mode conditioning cable. I get the following logged and port goes down after a few minutes.%SFF8472-5-THRESHOLD_...

Hi All,If I have multiple NAT statements on a router how are they processed? Is there some sort of sequential order or does it use the more specific statement?E.G if I have a NAT command which has an ACL denying certain traffic, but another NAT comma...

GRANT3779 by Spotlight
  • 514 Views
  • 2 replies
  • 0 Helpful votes