Routing

I can't access internet through the routerCould someone help get ip, but not out to internetinterface GigabitEthernet0/1 no ip address duplex auto speed auto pppoe enable group global pppoe-client dial-pool-number 1!interface Dialer1 ip address negot...

                   So my external is 72.186.194.70 /18 and I need ports tcp/udp 27000 through 27040 and 1200 forwarded to internal host 192.168.1.3.I already have overload for internal hosts running on NAT. How do I change the destination IP on its w...

Dears,I have cisco 3850 switch with with ios      3.03.01SE .How we can enable webgui for 3850s. i referred the below link to do this activityhttp://www.cisco.com/en/US/docs/switches/lan/catalyst3850/software/release/3se/system_management/configurati...

Hi,I'm trying to do transparent bridging with the following setup but im unable to pass traffic from R1 to the PE router. My goal is to use R2 as a L2 bridge to get connectivity between R1 and PE1. R1 doesn't have the necessary module hence this setu...

Hello,I've an 887va (used for providing internet via ADSL at a remote site).From the inside 192.68.0.x network we all users out on all ports (unrestricted).I've a requirement to allow SSH, HTTPs, SNMP and PING from 2 remote external IPs to the assign...

Hello. Given the following topology:R1#SW1-----           |          SW3--Host           #          SW4--Host           |R2#SW2-----R1 and R2  are connected via an Ethernet dot1q Trunk to SW1/SW2. On SW1/SW2 there're static access ports which connect...

HI Friends,Having issue with EIGRP in Nexus 7k while redistrubuting static routes. I have two core Nexus 7K's , which are connected service provider. Below Core I have distribution running in EIGRP. Goal is to achieve autmated failover between servic...

Hello,I'd be grateful if someone could share template or enlighten me on what kind of config I should be applying to an Internet router in terms of hardening and routing policies. These routers will have BGP peering with the ISP. And also have OSPF n...

Dear, I have CISCO887VA-M-K9 router and I have activated the eavluation advipservices license on it as below:ROUTER#show license featureFeature name             Enforcement  Evaluation  Subscription   Enabled  RightToUseadvipservices            yes  ...

why the interface of the router crashes when I try to add or delete mac addresses from the list?

Hi,I've recently got a Cisco 887va. I have followed this guide to setting the ADSL2+ up and it worked fine:https://supportforums.cisco.com/message/3578292#3578292My 887va is also on 192.168.1.1I can get out onto the internet - everything is working g...