Routing

Hi,I've recently got a Cisco 887va. I have followed this guide to setting the ADSL2+ up and it worked fine:https://supportforums.cisco.com/message/3578292#3578292My 887va is also on 192.168.1.1I can get out onto the internet - everything is working g...

I saw some (--) low alarms on my optics.I'm wondering if these alarms can cause any kind of problem.Has anyone experience ?Tks#sh inter transceiverTransceiver monitoring is disabled for all interfaces.If device is externally calibrated, only calibrat...

Problem:We have setup IPSLA on a core switch and are having problems with BGP not dropping Route_1. Setup:We've setup IPSLA (on Switch_01) in our network to determine if a route, Route_1, is available. If it is available, then traffic flows normally....

We have sites which has basic IP connectivity for supporting the data traffic and other applications and using the WAN connections. Currently we have got a new requirement to provision a point-to-point tunnel using serial interface and to connect to ...

I have a similar issue:https://supportforums.cisco.com/message/4088267#4088267ATT says that they have activated the profile but my profile is showing inactive. When I call ATT they say that they can see the device register and I'm seeing the number a...

Could anyone please tell me what the difference is between, for example, s72033-adventerprisek9-mz.122-33.SXJ6.bin and s72033-adventerprisek9_wan-mz.122-33.SXJ6.bin?  Cisco's Feature Navigator shows no features unique to either of them, and yet one i...

I want to limit bandwidth on one of my WAN router connected interface can you guys share which is best option to do thisRouter model cisco 3845Thanks for your help

Hello,i have some issues with routes learned over a mpls backbone. The setup is like thisSwitch1 ---------- Switch2   |                        |Router 1           Router2   |                        |   ------ MPLS --------              |         Rout...

Hi Guys,I've been struggling with this one for a few days now - I'm sure its something simply that I've overlooked but for the life of me I can't see it, so I'm hoping a fresh set of eyes might do the trick.Situation=======     Cisco 887W Router (IOS...

   Hello,I am trying to see if the following can work. access-list extended Out     permit udp host 239.10.10.1 range 1020 1030 anyaccess-list extended In     permit udp any host 239.10.10.1 range 1020 1030int vlan 10     ip access-group Out out     ...

Hi All,          I am not  able to understand what is the use of SOO. I tried searching in Google  and some say its used with as-overide and only when BGP is used between  PE and CE to avoid loop. I tried with the following topology and my  doubt is ...